Filter
Top Products
Introduction
7
Preparation
■ To listen to a Digital Audio Player
NOTE
• The System automatically switches the source to
LINE when the connected Digital Audio Player
starts to play—QP Link ( page 18).
• The sound signal from the Digital Audio Player
cannot be transmitted through the LINE OUT
jack.
■ To record on a Digital Audio Player from the
System
NOTE
• Before recording on a Digital Audio Player,
deactivate QP Link ( page 18) or do not
connect the Digital Audio Player to the LINE IN
jack; otherwise, LINE will be selected as the source
and the recording will stop.
• After making all other necessary connections,
connect the power cord.
• When you unplug the power cord or if a power
failure occurs, the clock is reset to "0:00" and the
timers will be canceled. You will need to set the
clock ( page 8) and the timers ( page 19
-21) again.
When you connect the power plug into the AC
outlet, "Hello" then "DEMO START!" appears on
the display window and the demonstration display
starts.
To deactivate the demonstration display, follow the
procedure below:
While the power is turned off...
Hold down on the main unit until
"DEMO CLEAR" appears on the
display window.
■ To activate the demonstration display again
While the power is turned off...
Hold down on the main unit until "Hello"
appears on the display window.
• The System will be turned on and the
demonstration display will start.
NOTE
• To stop the demonstration display, operate the
System. "DEMO OFF" appears on the display
window.
Connecting a Digital Audio
Player
Stereo mini plug audio
cord (not supplied)
To the audio output
Main unit (front view)
Stereo mini plug audi
o
cord (not supplied)
To the audio input
Main unit (front view)
Connecting the Power Cord
Disabling the Demonstration
Display
AC outlet Main unit (rear view)
Do not connect the AC power cord until all other connections have been made.
UX-QX3W_A[A].book Page 7 Friday, July 21, 2006 4:37 PM