JVC UX-G4 Speaker System User Manual


 
20
English
Using the Timers
There are four timers available—Daily Timer, Recording
Timer, Snooze Timer, and Sleep Timer.
Before using these timers, make sure the built-in clock is
set correctly (see page 9).
Using Daily Timer and Recording Timer
You can set the timer whether the unit is on or off.
How the Timer actually works
When the on-time comes, the unit automatically turns on (the
[timer] indicator flashes and continues flashing while the
timer is operating). Then, when the off-time comes, the unit
automatically turns off (standby). The timer setting remains
in memory until you change it.
•When the (timer) and DAILY 1, 2, or 3 indicators are lit
on the display, the timer acts as the Daily Timer. Once the
timer has been set, it will be activated at the same time and
automatically turns off (standby) after 60 minutes everyday
until the timer is deactivated.
When the (timer) and the REC indicators are lit on the
display, the timer acts as the Recording Timer. After the
timer-recording finishes, the details of the setting remain
stored but the timer is turned off.
Before you start...
When using “TUNER” as the source to play, make sure to
select the desired station before turning off the power.
•There is a time limit in doing the following steps. If the
setting is canceled before you finish, start again from step
1
.
Daily 1 Timer
Daily 2 Timer
Daily 3 Timer
CLOCK
/TIMER
On the remote control ONLY:
1
Press CLOCK/TIMER repeatedly to
select the timer you want to adjust
and activate—Daily 1, Daily 2, Daily
3, or Rec.
The timer setting and hour indication start flashing on the
display.
Each time you press the button, the display changes as
follows:
2
Set the on-time you want the unit to turn on.
(1) Press UP or DOWN to set the hour,
then press SET.
(2) Press UP or DOWN to set the minute,
then press SET.
If you want to change the time
setting, press CANCEL.
If you are setting the Daily Timer, the
source name starts flashing on the display.
\ Go to step
4
.
If you are setting the Recording Timer,
the OFF indicator and hour indication start
flashing on the display.
Clock setting
Normal indication
Rec Timer
SET
PRESET
GROUP
UP
DOWN
PRESET
GROUP
ON
DAILY 1
ON
DAILY 2
ON
DAILY 3
ON
REC
Continued
EN20-22_UXG4G3[UW] 05.5.9, 4:19 PM20