JVC UX-G4 Speaker System User Manual


 
7
English
Connecting Other Equipment
To connect an audio equipment
You can connect audio equipment—used only as a playback
device.
DO NOT connect any equipment while the
power is on.
DO NOT plug in any equipment until all
connections are complete.
For playing other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX jack by using audio cords with mini
plugs (not supplied).
When the audio equipment has pin jacks for audio output:
Be sure that the pin plugs of the audio cords are colored—
white plugs and jacks are for left audio signals, and red ones
for right audio signals.
L
R
AUX
To
Audio equipment
To audio output
To audio output
To remove the speaker grilles
The speaker grilles are removable as the illustration below.
To remove the speaker grille, insert your fingers around the
projection at the top of the speaker grille, then pull gently
towards you while holding the side.
Do the same for the rest of projections one at a time.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
Speaker grille
Holes
Projections
OR
Do not connect the power cord until all other connections have been made.
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Use a screwdriver to move the voltage selector so the voltage
number is the same as the voltage where you are plugging in
the unit. (See the back cover page.)
AC 110-127V
VOLTAGE SELECTOR
AC 220-240V
EN06-08_UXG4G3[UW] 05.5.11, 11:27 AM7