Filter
Top Products
9
English
Using the Tuner
You can listen to FM and AM stations. Stations can be tuned in
manually, automatically, or from preset memory storage.
❏ Before listening to the radio:
• Make sure that both the FM and AM antennas are correctly
connected. (See pages 4 and 5).
Setting the AM Tuner Interval Spacing
When shipped, the AM tuner interval is set to 9 kHz spacing
(50 kHz spacing for FM broadcast). You can change it to 10 kHz
spacing.
To select 10 kHz intervals, while holding down the ¢ button
on the Unit in Standby mode, press the
%
button on the Unit to
turn on the power (at the same time, the 100 kHz spacing is select-
ed for FM broadcast).
To select 9 kHz intervals again, while holding down the 4
button on the Unit in Standby mode, press the
%
button on the
Unit to turn on the power.
One Touch Radio
Just press the FM/AM button to turn on the System and start play-
ing the station you were last tuned to.
❏ You can switch from any other sound source to the radio by
pressing the FM/AM button.
Tuning In a Station
1
Press the FM/AM button.
The Band and Frequency you were last tuned to appear on the
display.
(If the last station was selected using the preset number, the
preset number appears first.)
Each time you press the button, the band alternates between
FM and AM.
EJECT EJECT
REC / PLAY
B
CD SYNCHRO RECORDING
PLAY
A
FULL - LOGIC CONTROL
AUX
CD
TAPE
FM
/ AM
FM MODE
Numeric
keys
SET
¡
* When the System is in use, the display shows other items as well.
For simplicity, we show here only the items described in this section.
kHz MHz
MONO
ST
1
Band display, Frequency display, Preset channel
FM mode indicators
FM/AM
FM/AM
22
¢
4
STANDBY
STANDBY/ON
STANDBY
STANDBY/ON
[10 kHz Intervals] [9 kHz Intervals]
FM /AM
FM
/ AM
(on the Unit)
(on the Remote Control)
or
MX-GA3V(US).book Page 9 Thursday, April 10, 2003 9:45 AM