Filter
Top Products
63
Operating Video Components
IMPORTANT:
To operate JVC’s video components using this remote control:
• Some JVC VCRs can accept two types of the control signals—
remote codes “A” and “B.” Before using this remote control, make
sure that the remote control code of the VCR connected to the VCR
1 jacks is set to code “A.”
–When another JVC VCR is connected to the VCR 2 and VIDEO
jacks, set its remote control code to code “B.” (This remote control
cannot emit the control signals of code “B.”)
• To operate the video component(s) using the remote control:
–Aim the remote control directly at the remote sensor on each
component, not on the receiver.
When using the remote control:
–Set the TV operation mode selector to “TV” or
“CATV/DBS” correctly.
To operate TV, set it to “TV.”
–Check the indication shown on the remote’s display
when you press a button—this indicates the remote
control operation mode for a while.
–The CONTROL button can change the remote control operation
mode without changing the source.
Each time you press the button, the remote control operation mode
changes in the sequence—VCR1 = TAPE = CDR = CD DISC =
(back to the beginning).
VCR (VCR connected to the VCR 1 jacks)
You can always perform the following operations:
VCR 1
: Turns on or off the VCR.
After pressing VCR 1 or selecting “VCR1” by pressing CONTROL
repeatedly, you can perform the following operations on the VCR:
1 – 9, 0 : Selects the TV channels on the VCR.
PLAY : Starts playing.
REW : Rewinds a tape.
FF : Fast-winds a tape.
STOP : Stops operations.
PAUSE : Pauses playing. To release, press PLAY.
¶ REC : Press this button together with the PLAY button
to start recording.
Press this button together with the PAUSE button
to enter recording pause.
CHANNEL +/– : Changes the TV channels on the VCR.
DVD player
You can always perform the following operations:
DVD
: Turns on or off the DVD player.
After pressing DVD or DVD MULTI, you can perform the following
operations on the DVD player:
1 – 10, 0, +10 : Selects the DVD titles or the chapters.
PLAY : Starts playing.
4 : Returns to the beginning of the current (or
previous) chapter.
¢ : Skips to the beginning of the next chapter.
STOP : Stops playing.
PAUSE : Stops playing temporarily. To release, press
PLAY.
After pressing DVD MENU, these
buttons can be used for the DVD
menu operations.
Note:
Refer also to the manual supplied for your DVD player (and the
instruction supplied for the discs).
TV
You can always perform the following operations (with the TV
operation mode selector set to “TV”):
TV/DBS : Turns on or off the TV.
TV VOL +/– : Adjusts the volume.
TV/VIDEO : Sets the input mode (either TV or VIDEO).
After pressing TV/DBS (with the TV operation mode selector set to
“TV”), you can perform the following operations on a TV:
CHANNEL +/– : Changes the channels.
1 – 9, 0, 100+ : Selects the channels.
RETURN : Alternates between the previously selected
channel and the current channel.
TV
CATV/
DBS
DVD
TV/DBS
VCR 1
AUDIO
TRANSMIT
LEARN
TRANSMIT
LEARN
Ex.When you press VCR1
SET
DVD
MENU
EN61-74_RX-DP20VSL[B]f.pm5 03.5.21, 19:0763