Filter
Top Products
51
❏ Changing the transmittable signals for operating
a VCR
1
Press and hold VCR .
2
Press VCR.
3
Enter the manufacturer’s code using buttons
1 – 9, and 0.
See “Manufacturers’ codes for VCR” on the right.
4
Release VCR .
Now, you can perform the following operation on the VCR.
VCR : Tu rn on or off the VCR.
After pressing VCR, you can perform the following operations
on the VCR.
CHANNEL +/–: Change the channel numbers on the
VCR.
1 – 10, 0, +10: Select the channel numbers on the VCR.
3: Start playback.
7: Stop playback.
8: Pause playback.
FF: Fast-wind a tape.
REW: Rewind a tape.
+ 3: Start recording.
+ 8: Enter recording pause. To start
recording, press this button then 3.
See the instructions supplied with the VCR for details.
5
Try to operate your VCR by pressing VCR .
When your VCR turns on or off, you have entered the correct
code.
If more than one code is listed for your brand of VCR, try each
one until the correct one is entered.
Manufacturers’ codes for VCR
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
Manufacturer Codes
JVC 01, 02, 03, 04
Aiwa 05
Akai 06, 07, 08
Bell+Howell 09
Daewoo 10
Emerson 11, 12, 13, 14, 15
Fisher 16, 17, 18, 19
G.E. 20, 21
Go Video 22
Gold Star 23
Go-Video A 24
Go-Video B 25
Hitachi 20, 26
Magnavox 27, 28, 29
Mitsubishi 30, 31, 32, 33
NEC 34, 35
Panasonic 36, 37
Philips 27
RCA 38
Samsung 39, 40, 41
Sanyo 16, 17, 18, 19
Scott 42
Sharp 43, 44
Shintom 45
Sony 46, 47, 48, 49, 50, 51
Symphonic 52
Teknica 53, 54
Toshiba 55
Zenith 56
Initial setting: 01
48-52RX-D702B[UJ].p65 05.9.9, 4:50 PM51