Filter
Top Products
37
English
Operating Other Manufacturers’ Video Equipment
By changing the transmittable signals, you can use the remote
control supplied for this unit to operate other manufacturers’
equipment.
• Refer also to the manuals supplied for the other products.
• To operate these components with the remote control, first you
need to set the manufacturers’ code each for TV, CATV converter,
VCR and DVD player.
• After replacing batteries of the remote control, set the
manufacturers’ codes again.
To change the transmittable signals
for operating a TV
1
Set TV/CATV selector to TV.
2
Press and hold STANDBY/ON TV/CATV.
3
Press TV SOUND.
4
Enter manufacturer’s codes using buttons 1 – 9,
and 0.
5
Release STANDBY/ON TV/CATV.
Now, you can perform the following operations on the TV.
STANDBY/ON TV/CATV
: Turn on or off the TV.
TV/VIDEO : Set the input mode (either TV or VIDEO).
TV VOLUME +/– : Adjust the volume.
TV/CATV CH +/– : Change the channels.
After pressing TV SOUND (source selecting button), you can
use the following buttons on the TV:
1 – 10, +10 (100+) : Select a channel. +10 (100+) button will
function as the ENTER button if your
equipment requires pressing ENTER after
selecting a channel number.
Note:
Refer also to the manual supplied with your TV.
6
Try to operate your TV by pressing
STANDBY/ON
TV/CATV.
When your TV turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of TV,
try each one until the correct one is entered.
TO BE CONTINUED TO THE NEXT PAGE
Manufacturers’ codes for TV
*
“01” is the initial setting.
Manufacturer Codes
JVC 01*
Hitachi 10
Magnavox 02
Mitsubishi 03
Panasonic 04, 11
RCA 05
Samsung 12
Sanyo 13
Sharp 06
Sony 07
Toshiba 08
Zenith 09
To change the transmittable signals for
operating a CATV converter
1
Set TV/CATV selector to CATV.
2
Press and hold STANDBY/ON TV/CATV.
3
Press TV SOUND.
4
Enter manufacturer’s codes using buttons 1 – 9,
and 0.
5
Release STANDBY/ON TV/CATV.
Now, you can perform the following operations on the CATV
converter.
STANDBY/ON TV/CATV
: Turn on or off the CATV converter.
TV/CATV CH +/– : Change the channels.
After pressing TV SOUND (source selecting button), you can
use the following buttons on the CATV converter:
1 – 10, +10 (100+) : Select a channel. +10 (100+) button will
function as the ENTER button if your
equipment requires pressing ENTER after
selecting a channel number.
Note:
Refer also to the manual supplied with your CATV converter.
EN30-42.RX-7520V[C]f.pm5 02.2.14, 4:33 PM37