Filter
Top Products
36
English
Operating Video Components
IMPORTANT:
To operate JVC’s video components using this remote control:
• You need to connect JVC’s video components through the AV
COMPU LINK terminals (see page 32) in addition to the
connections using cables with RCA pin plugs (see pages 7 and 8).
• Some JVC’s VCRs can accept two types of the control signals—
remote code “A” and “B.” Before using this remote control, make
sure that the remote control code of the VCR connected to the
VCR jacks is set to code “A.”
• When using the remote control:
– For the DVD player and VCR operations, aim the remote control
directly at the remote sensor on each component, not on the
receiver.
– For the TV having the AV COMPU LINK terminal, aim the remote
control directly at the remote sensor on the TV.
VCR
You can always perform the following operations:
STANDBY/ON VCR
: Turn on or off a VCR.
VCR CH +/– : Change the TV channels on the VCR.
After pressing VCR (source selecting button), you can use the
following buttons for VCR operations:
33
33
3 : Start playback.
FF : Fast wind a tape.
REW : Rewind a tape.
77
77
7 : Stop playback or recording.
88
88
8 : Pause playback. To release it, press
33
33
3.
REC PAUSE : Press this button to enter recording pause.
Press this button then 3 to start recording
Operating JVC’s Audio/Video Components
TEST
EFFECT
MENU
ENTER
CENTER
REAR L
SUBWOOFER
REAR R
1
4
7/P
10
2
5
8
0
3
6
9
10
100
RETURN
DVD player
You can always perform the following operations:
STANDBY/ON DVD
: Turn on or off a DVD player.
After pressing DVD or DVD MULTI (source selecting button), you
can use the following buttons for DVD operations:
33
33
3 : Start playback.
4 : Return to the beginning of the current
(or previous) chapter.
¢ : Skip to the beginning of the next chapter.
77
77
7 : Stop playback.
88
88
8 : Pause playback. To release it, press
33
33
3.
DVD menu operations
After pressing DVD or DVD MULTI
(source selecting button), you can use
the following buttons for DVD menu
operations:
MENU : Display or erase the menu screen.
55
55
5/
∞∞
∞∞
∞/
33
33
3/
22
22
2 : Select an item on the menu screen.
ENTER : Enter a selected item.
TV
Before operating, set TV/CATV selector to TV.
You can always perform the following operations:
STANDBY/ON TV/CATV
: Turn on or off a TV or a CATV converter.
TV/VIDEO : Change the input mode (TV tuner and video
input).
TV VOLUME +/– : Adjust the volume.
TV/CATV CH +/– : Change the channels.
After pressing TV SOUND (source selecting button), you can use
the following buttons for TV operations:
1 – 9, 0, +10 (100+) : Select a channel.
RETURN (10) : Function as tme RETURN button.
EN30-42.RX-7520V[C]f.pm5 02.2.14, 4:33 PM36