Filter
Top Products
35
IMPORTANT:
To operate JVC video components using this remote control:
• Aim the remote control directly at the remote sensor on the VCR or TV, not on
the receiver.
77
77
7 After pressing VCR, you can perform the
following operations on the VCR:
3 Starts playback.
4 Rewinds a video tape.
¢ Fast winds a video tape.
7 Stops operation.
8 Pauses. To resume playing, press 3.
You can always do the following on the VCR:
• Change the channels on the VCR using the VCR
CH +/– button.
• Turn on and off the VCR by pressing VCR in
the POWER section.
77
77
7 You can always perform the following operations
on the TV:
• Change the TV’s input mode to either “TV” or
“VIDEO” using the TV/VIDEO button.
• Change the TV volume using the TV VOL. +/–
button.
• Change the channels on the TV using the TV CH
+/– button.
• Turn on and off the TV by pressing TV in the
POWER section.
Note:
If you choose a source on the front
panel, the remote control will not
operate that source.
Operating Other Components
CD
456
123
TV VCR
POWER
AUDIO
EFFECT DELAY
3D-PHONIC
SURROUND
TEST
TAPE
7/P 8 9
10
SEA
PRESET
+10
TUNER/
BAND
VCR
SOUND
CONTROL
CD-DISC
VIDEO
RM-SR554U REMOTE CONTROL
–+
PHONO
TV/
VIDEO
MUTING
ONE TOUCH
OPERATION
VCR CH
–+
CENTER
–+
REAR
–+
TV CH
–+
TV VOL.
–+
VOLUME
DAP MODE
SEA MODE
Notes:
• If you press SOUND
CONTROL, you cannot
operate the VCR with this
remote control. If this happens,
press the VCR again, so
operating buttons for video
components will work for the
VCR.
• If you press the VCR (the one
of the source selection) on the
remote control aiming at the
JVC TV, the TV’s input mode
will change to the video input.
RX-554VBK(J)_0117-001B_En.20-38 98.1.6, 11:38 AM35