Filter
Top Products
28
SURROUND
Preparing for Surround Modes
Once you have set the surround modes, you can use the same adjustment every time you
want to activate the surrround mode you want. The receiver memorizes surround
adjustments for each mode.
On the front panel:
1. Press SURROUND so that the Control
%%
%%
% /
fifi
fifi
fi buttons
work for selecting the surround modes.
The lamp above the button lights up.
2. Press Control
%%
%%
% /
fifi
fifi
fi to select one of the surround
mode (“PROLOGIC”, “3CHLOGIC” or
“THEATER”).
Each time you press the button, the surround modes
change as follows:
PROLOGIC Select this mode when you use a center speaker and rear
speakers.
THEATER Select this mode to watch a video source with Dolby Surround
when you have connected the rear speakers (and a center
speaker). This mode gives you the feeling of a movie theater.
3CHLOGIC Select this mode when you use a center speaker without rear
speakers.
OFF Select this to turn off the surround/DAP/3D-PHONIC modes.
* You cannot select the 3D-PHONIC modes or the DAP modes in this step.
For the 3D-PHONIC modes: see pages 23 and 24.
For the DAP modes: see pages 25 and 26.
3. Press ADJUST so that the Control
%%
%%
% /
fifi
fifi
fi /
@@
@@
@ /
##
##
#
buttons work for adjusting the selected surround
mode.
The lamp above the button lights up.
4. Press Control
%%
%%
% /
fifi
fifi
fi until “CNT MODE” (Center
Mode) appears on the display.
Continued to the next page.
Ex.
PROLOGIC THEATER
PAVILION*
3CHLOGIC
3DACTION*
OFF
Note:
When one of the surround modes
is selected, the corresponding
indicator lights up on the display.
ADJUST
Note:
If you have already set the center
speaker size following the
procedure described on page 15,
you do not have to select the
center mode in this procedure.
RX-554VBK(J)_0117-001B_En.20-38 98.1.6, 11:37 AM28