Filter
Top Products
33
ENGLISH
To change the password
If you want to change the password after you
have registered it, follow the procedure below.
1 Press SEL (S) and ¢ at the same time for
more than 2 seconds.
“ ” appears on the display.
2 Enter the current password correctly, then
press SEL (S).
The unit enters password entry mode.
3 Enter a new password as you want, then press
SEL (S).
The unit returns to the normal operation mode.
• See page 32 for details on how to enter the
password.
When Security Lock works?
Once you register the password, “ ”
appears on the display, and the unit will ask you
to enter the password in the following cases:
• When you turn on the unit for the first time after
re-installing the unit.
• When you turn on the unit for the first time after
replacing the car battery.
To use this unit, you must enter the correct
password by following the procedure below.
1 Press DISP (D) to select the character set you
want.
2 Turn the control dial to enter a character.
3 Press ¢ or 4 to move the character
entry position.
4 Repeat steps 1 to 3 to enter the entire
password (4 letters) correctly, then press
SEL (S).
•If you enter the correct password, the security
lock is canceled and you can use the unit
normally.
•In the following cases, the security lock is not
canceled (“NOT ACCEPT” appears on the
display) then the unit turns off. (The unit will
never turn on unless you press the reset
button on the front panel. See page 2.)
– If you enter an incorrect password then
press SEL (S).
– If you cannot finish entering the correct
password (each character within 30
seconds.)
If you enter an incorrect character while
entering the password
Press 4 to move back the character entry
position over the incorrect character, then repeat
steps 1 and 2 to select the correct character.
EN25-33KD-LX333_111R[E]4.pm5 12/22/01, 6:22 PM33