Filter
Top Products
28
ENGLISH
To select the subwoofer cutoff frequency
— WooferFreq (only for KD-LX333R)
When a subwoofer is connected to this unit,
select an appropriate cutoff frequency level for
your subwoofer. When shipped from the factory,
the subwoofer cutoff frequency is set to “FREQ
MID.”
• FREQ LOW: Frequencies higher than
50 Hz are cut off to the
subwoofer.
• FREQ MID: Frequencies higher than
80 Hz are cut off to the
subwoofer.
• FREQ HIGH: Frequencies higher than
120 Hz are cut off to the
subwoofer.
To adjust the line input level — LINE ADJ
(only for KD-LX333R)
Adjust the line input level properly when an
external component is connected to the LINE
INPUT plugs. When shipped from the factory, the
line input level is set at level “00.”
If the input level of the connected component is
not high enough, increase the input level
properly. Without adjusting the line input level,
you may be surprised at a loud sound when you
change from the external component to another
source.
To select the external component to use
–– EXT INPUT (only for KD-LX111R)
You can connect the external component to the
CD changer jack on the rear using the Line Input
Adaptor KS-U57 (not supplied).
To use the external component as the playback
source through this unit, you need to select
which component – CD changer or external
component – to use. When shipped from the
factory, CD changer is selected as the external
component.
• LINE INPUT: To use the external component
other than CD changer.
• CD CHANGER:To use the CD changer.
Note:
For connecting the Line Input Adaptor KS-U57 and
the external component, refer to the Installation/
Connection Manual (separate volume).
To make the front panel look flat (hiding
the control panel) — FLAT PANEL
When operating the receiver using the remote
control, you can hide the control panel to make
the front panel look flat. When shipped from the
factory, “FLAT OFF” is selected.
• FLAT ON: The control panel will not come
out when you turn on the unit.
To use the control panel, press
4 so that the control
panel comes out. If no
operation is done for about 10
seconds, it automatically goes
back into the receiver.
• FLAT OFF: You can use the control panel
normally.
Note:
When “FLAT ON” is selected, you can eject a CD by
holding 4 .
To change the FM tuner selectivity
— IF FILTER
In some areas, adjacent stations may interfere
with each other. If this interference occurs, noise
may be heard. This unit has been preset to
automatically reduce this interference noise
(“AUTO”) when shipped from the factory.
• AUTO: When this type of interference
occurs, this unit automatically
increases the tuner selectivity
so that interference noise will
be reduced. (But the stereo
effect will also be lost.)
• WIDE: Subject to the interference from
adjacent stations, but sound
quality will not be degraded
and the stereo effect will not be
lost.
EN25-33KD-LX333_111R[E]4.pm5 12/22/01, 6:21 PM28