Filter
Top Products
5
⁄
Front speakers
• When connecting the speaker cords, match the polarity of
the speaker terminals: (+) to (+) and (–) to (–).
•
Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit
.
• The speakers are magnetically shielded to avoid color
distortions on TVs. However, if not installed properly, it
may cause color distortions. So, pay attention to the
following when installing the speakers.
– When placing the speakers near a TV set, turn off the TV’s
main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV’s
main power switch again.
Some TVs may still be affected even though you have
followed the above. If this happens, move the speakers away
from the TV.
@
Surround speakers (for MX-JE5)
• When connecting the speaker cords, match the polarity of
the speaker terminals: (+) to (+) and (–) to (–).
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
MAIN SPEAKERS
CAUTION:
SPEAKERS IMPEDANCE
6
Ω
–16
Ω
SURROUND SPEAKERS
CAUTION:
SPEAKERS IMPEDANCE
16
Ω
–32
Ω
CAUTION:
SPEAKERS IMPEDANCE
6
Ω
–16
Ω
SPEAKERS
From right
front main speaker
From left
front main speaker
MX-JE5
From right front main
speaker
From left front main
speaker
MX-JE3/MX-JE31
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
To remove the speaker grilles (for MX-JE5/MX-
JE31)
Holes
Speaker
grille
Projection
The illustration above is for MX-JE5.
MAIN SPEAKERS
CAUTION:
SPEAKERS IMPEDANCE
6
Ω
–16
Ω
SURROUND SPEAKERS
CAUTION:
SPEAKERS IMPEDANCE
16
Ω
–32
Ω
From left surround
speaker
From right surround
speaker