JVC MX-JE5 Stereo System User Manual


 
41
Timer Operations
(see pages 34 to 35)
Setting the Timer:
If you do not specify the preset station or track number
correctly while setting a timer, the currently selected
station or the first track will be played when timer is
activated.
When you unplug the AC power cord or if a power failure
occurs, the timer will be canceled. You need to set the
clock first, then the timer again.
Without stopping the recording, you cannot change the
source after Recording Timer starts recording.
If you set DVD Video as the source, Daily Timer will not
work correctly.
Timer Priority:
If you set the Sleep Timer after Daily Timer starts playing
the selected source, Daily Timer is canceled.
If you set the Sleep Timer after Recording Timer starts
recording, Recording Timer is canceled, but recording
continues until Sleep Timer shuts off the power.
Setup Menu Operations
(see pages 36 to 37)
General:
If the upper and lower parts of the menu are cut off, adjust
the picture size control of the TV.
LANGUAGE menu:
When the language you have selected for MENU
LANGUAGE, AUDIO LANGUAGE, or SUBTITLE is
not recorded on a disc, the original language is used as the
initial language.
PICTURE menu—MONITOR TYPE:
Even if “4:3 PS (MULTI)” is selected, the screen size may
become 4:3 letter box with some DVD Videos. This
depends on how the discs are recorded.
When you select “16:9 (MULTI)” for a picture whose
aspect ratio is 4:3, the picture slightly changes due to the
process for converting the picture width.
AUDIO menu—DOWN MIX:
This setting is not effective when DTS multi-channel
software is played back.
OTHERS menu—ON SCREEN GUIDE:
The setup menu and on-screen bar will be displayed (and
recorded) even though this function is set to “OFF.”
Subtitles and the information for zoom-in always appear
on the display regardless of this setting.
Maintenance
To get the best performance of the System, keep your discs,
tapes, and mechanism clean.
Handling discs
Remove the disc from its case by holding it at the edge
while pressing the center hole lightly.
Do not touch the shiny surface of the disc, or bend the disc.
Put the disc back in its case after use to prevent warping.
Be careful not to scratch the surface of the disc when
placing it back in its case.
Avoid exposure to direct sunlight, temperature extremes,
and moisture.
To clean the disc:
Wipe the disc with a soft cloth in a straight line from center
to edge.
Handling cassette tapes
If the tape is loose in its cassette, take up the slack by
inserting a pencil in one of the reels and rotate it.
If the tape is loose, it may get stretched, cut, or caught in
the cassette.
Be careful not to touch the tape surface.
Avoid the following places to store the tape—in dusty
places, in direct sunlight or heat, in moist areas, on a TV or
speaker, or near a magnet.
To keep the best recording and playback sound quality:
Use a cotton swab moistened with alcohol to clean the
heads, capstans, and pinch rollers.
Use a head demagnetizer (available at electronics and
audio shops) to demagnetize the heads (when the System
turned off).
Cleaning the System
Stains should be wiped off with a soft cloth. If the System
is heavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe clean
with a dry cloth.
Since the System may deteriorate in quality, become
damaged or get its paint peeled off, be careful about the
following:
DO NOT wipe it with a hard cloth.
DO NOT wipe it strong.
DO NOT wipe it with thinner or benzine.
DO NOT apply any volatile substance such as
insecticides to it.
DO NOT allow any rubber or plastic to remain in contact
for a long time.