Filter
Top Products
5
Getting Started
This section explains how to connect audio/video components and speakers to the receiver, and how to connect the
power supply.
Before Installation
General Precautions
• Be sure your hands are dry.
• Turn the power off to all components.
• Read the manuals supplied with the components you are going to
connect.
Locations
• Install the receiver in a location that is level and protected from
moisture.
• The temperature around the receiver must be between –5˚C and
35˚C.
• Make sure there is good ventilation around the receiver. Poor
ventilation could cause overheating and damage the receiver.
Handling the receiver
• Do not insert any metal object into the receiver.
• Do not disassemble the receiver or remove screws, covers, or
cabinet.
• Do not expose the receiver to rain or moisture.
Checking the Supplied Accessories
Check to be sure you have all of the following items, which are
supplied with the receiver.
The number in the parentheses indicates quantity of the pieces
supplied.
• Remote Control (1)
• Batteries (2)
• AM Loop Antenna (1)
• FM Antenna (1)
• AC Plug Adaptor (1)
If anything is missing, contact your dealer immediately.
Setting the Voltage Selector
Before connections, always do the following first if necessary.
Select the correct voltage in VOLTAGE SELECTOR on the rear by
using a screw driver. Check to be sure if the voltage mark is set to
the voltage for your area where this unit plugs in.
ANTENNA
AM
EXT
AM
LOOP
FM 75
COAXIAL
AM
LO
O
P
ANTENNA
AM
EXT
FM
75
C
O
A
XIA
L
AM
LO
O
P
ANTENNA
AM
EXT
FM
75
C
O
A
XIA
L
A. Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM 75 Ω
COAXIAL terminal as temporary measure.
B. Using the Standard Type Connector (not supplied)
A standard type connector should be connected to the FM 75 Ω
COAXIAL terminal.
Note:
If reception is poor, connect the outdoor FM antenna (not supplied).
Before attaching a 75
Ω
coaxial cable (the kind with a round wire
going to an outdoor antenna), disconnect the supplied FM antenna.
B
FM Antenna (supplied)
Outdoor FM Antenna Cable (not
supplied)
Extend the supplied FM antenna horizontally.
A
Connecting the FM and AM Antennas
FM Antenna Connections
VOLTAGE SELECTOR
220V
230
-
240V
127V
110V
Voltage mark
EN01-15.RX-8020V[A]_f 02.5.21, 10:15 AM5