Filter
Top Products
37
Using the DVD MULTI Playback Mode
This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD
player. Before playing back a DVD, refer also to the manual supplied with the DVD player.
When using DVD MULTI playback mode, connect the DVD player with its analog discrete output jacks (Å – ‰).
VIDEO
FRONT
RIGHT
LEFT
DVD
TV SOUND
DBS
OUT
(REC)
IN
(PLAY)
VCR1
OUT
(REC)
IN
(PLAY)
VCR2
MONITOR
OUT
S-VIDEOVIDEO
COMPONENT VIDEO
MONITOR
OUT
DBS
DVD
Y
P
B/CB
PR/CR
OUT
(REC)
IN
(PLAY)
IN
(PLAY)
OUT
(REC)
RIGHT
LEFT
PHONO
TAPE
MD
CDR
CD
AUDIO
DVD
SUB
WOOFER
CENTER
C
B
A
D
F
G
E
DVD
SURR
(REAR)
Activating the DVD MULTI Playback Mode
1. Press DVD MULTI so that “DVD MULTI”
appears on the display.
The DVD MULTI lamp on the front panel button and the DVD
MULTI indicator light up.
Note:
When you select “DVD MULTI” as the source to play, the
Surround and DSP modes are canceled, and the SURROUND
and DSP buttons do not work.
Å To surround left/right audio output
ı To center audio output
Ç To subwoofer output
Î To front left/right audio output
‰ To composite video output
Ï To S-video output
Ì To component video output
On the front panel
DVD MULTI
From the remote control
DVD MULTI
DVD player
2. Select the analog discrete output mode on the
DVD player, and start playing a DVD.
• Refer also to the manual supplied with the DVD player.
You can also adjust digital equalization patterns and
speaker output levels. See “Adjusting Sound” on
pages 38 to 41 for details.
• Test tone does not output through the speakers to adjust the
speakers output levels when selecting DVD MULTI.
Notes:
• Midnight Mode is not available for DVD MULTI playback mode (see
page 24).
• When using a pair of headphones, the sounds of front left and right
channels are output from the headphones.
EN32-37.RX-8020V[A]_f 02.5.21, 10:22 AM37