Filter
Top Products
18
ENGLISH
3
Start PTY search
for your favorite
programme.
• If there is a station broadcasting a programme of
the same PTY code as you selected, that station
is tuned in.
• If there is no station broadcasting a programme
of the same PTY code as you selected, the
station will not change.
Note:
In some areas, the PTY search will not work correctly.
Other convenient RDS functions
and adjustments
Setting the TA volume level
You can preset the volume level for TA Standby
Reception. When a traffic programme is received,
the volume level automatically changes to the
preset level.
• See also “Changing the general settings (PSM)”
on page 35.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
2 Press 5 (up) or ∞ (down) repeatedly until “Tuner”
is selected as the PSM category (it is shown on
the left side of the display).
3 Press ¢ or 4 to select “TA Volume.”
4 Turn the control dial to set to the desired volume.
You can set it from “Volume 0” to “Volume 50.”
5 Press SEL (select) to finish the setting.
Automatic selection of the station
when using the number buttons
Usually when you press the number button, the
preset station is tuned in.
However, when the preset station is an RDS station,
something different will happen. If the signals from
that preset station are not sufficient for good
reception, this unit, using the AF data, tunes in to
another frequency broadcasting the same
programme as the original preset station is
broadcasting. (Programme search)
• The unit takes some time to tune in to another
station using Programme search.
To activate programme search, follow the procedure
below.
• See also “Changing the general settings (PSM)”
on page 35.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
2 Press 5 (up) or ∞ (down) repeatedly until “Tuner”
is selected as the PSM category (it is shown on
the left side of the display).
3 Press ¢ or 4 to select
“P(Programme)-Search.”
4 Turn the control dial clockwise to select “On.”
Now programme search is activated.
5 Press SEL (select) to finish the setting.
To cancel programme search, repeat the same
procedure and select “Off” in step 4 by turning
the control dial counterclockwise.
EN14-19LH2000R[E]f.pm5 02.3.29, 4:23 PM18