*
1
When you stand the unit,
be careful not to damage the
fuse on the rear.
*
1
৹ʹጅइçʮ˻ʿ࠱
๑ᖢנ௰ڄۘᎳീé
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealers or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
Removing the unit
Before removing the unit, release the rear section.
2
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
• This unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• This unit does not work at all.
* Have you reset your unit?
ϰ༬༬éׇ֤ϛᄮڸؼ˗
ʓࡒڄ࿌༱ڷΕʄյܓڄϯ༫ദҺéϨسЉᖅçᄔ࠱Љᘕࢭ˔άڄཊऄçቁώJVC
ԆԾࡖᛏ˜ኀੋࢭ˔άաᏻ˙͌༿é
ëϨسʿᇧ׆Ϩщᇧϙϯ༫ʹጅçᏻቁϐतڄӑிʆ࢜գϯ༫é
Do the required electrical connections.
නмᄔڄྐཔé
Bend the appropriate tabs to hold the
sleeve firmly in place.
Ҿᛮጅೋڄߴдçӕ͙ࢭጅೋԕ֣Ϛᄭ
ڷػ˖é
։͵ጆ
Ϛ؛ֈʹጅۮçᏻઅʹጅ݈௰ڄ֣׆֜௰˜ᖑළé
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
ݝ࿌Εçઅղ̕ػܓӕ˾ʈ̿ᆥç݈ძᗌ
ϙનղώ͙ղ̕ӕ˾çʹጅᎲ˃̳é
When using the optional stay / ࠝΈ́ᆊނ
Screw (option)
ᒘീਐ·ڄ
Stay (option)
̀ᆉށ·ڄ
Fire wall
Վ̑ػ
Dashboard
ᄭڷػ
Install the unit at an angle of less than 30˚.
અʹጅϯ༫Ϛ˲ؠ30˚ڄԴܾé
When installing the unit without using the sleeve / ࠝˀՠΈ͚ࢮጆೌϰ༬͵ጆ
In a Toyota car for example, first remove the car radio and install the unit in its place.
̣ᕙΉ(TOYOTA) ԆԾբ ࡛ζ֊̳ԆԾЂࡖጅç݈અʹጅ༫ʈմڏ̳ڄтé
*
2
Not supplied for this unit.
*
2
ʿᎲʹጅಏաé
Flat type screws (M5 × 8 mm)
*
2
ͦᏃᒘീਐ (M5 × 8 mm)*
2
Pocket
ڏೋ
Flat type screws (M5 × 8 mm)
*
2
ͦᏃᒘീਐ (M5 × 8 mm)*
2
Bracket*
2
Ёࣙ*
2
Bracket*
2
Ёࣙ*
2
Note : When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are
used, they could damage the unit.
ٍิ !ӕʹጅϯ༫ϚЁࣙʕइçੀͫ՟·8 mmۂڄᒘീਐéϨ՟·ཫۂڄᒘീਐç๑ᖢʹጅé
ݮᄑਜ
•ۙᎴുጜᔄê
*ᐓފ߹иለᏃ֜෨иለᏃݵѴ᙮ᇧ%
•ྑກˀ়ોê
*ᐓފ෦иለᏃݵѴʕ%
•ಚᑶወԆЊᑶࡗê
*ᐓފಙᑵ᎔̳ለᏃݵѴഠཔ%
•ᑶࡗ͜ॳê
*ᐓފಙᑵ᎔̳ၷʪݵѴϙ%
*ᐓފಙᑵڄͣ(L)è͆(R) ၷʪڄ࠷(–) ݵѴθψϙ%
•ࡗʹᓿࡗᛐê
*݈ϙၷʪႩԾԽݵѴ՟·ཛഠ֜ཛ۹ڄྐለ%
•͵ጆഛᇋê
*ᐓފಙᑵ᎔̳ၷʪݵѴϙ%
*ᐓފಙᑵڄͣ(L)è͆(R) ၷʪڄ࠷(–) ݵѴθψϙ%
•͵ጆҭθˀ়ይіê
*ݵѴʵࡌڄጅஇ%
Instal1-2_KD-G725_010A_1.indd 2Instal1-2_KD-G725_010A_1.indd 2 13/12/05 11:41:03 AM13/12/05 11:41:03 AM