Filter
Top Products
A
2
Typical connections
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1 Connect the colored leads of the power cord in the order specified in the illustration below.
2 Connect the antenna cord.
3 Finally connect the wiring harness to the unit.
Other external component
*
7
Line Input Adapter KS-U57 (not supplied for this unit)
Connecting the external amplifiers and/or subwoofer
You can connect amplifiers to
upgrade your car stereo system.
• Connect the remote lead (blue
with white stripe) to the remote
lead of the other equipment so
that it can be controlled through
this unit.
•
Disconnect the speakers from
this unit, connect them to the
amplifier. Leave the speaker
leads of this unit unused.
*
3
Firmly attach the ground
wire to the metallic
body or to the chassis
of the car—to the place
uncoated with paint (if
coated with paint, remove
the paint before attaching
the wire). Failure to do so
may cause damage to the
unit.
• Set “EXT IN” for the external input setting (See page 14 of the INSTRUCTIONS.)
CAUTION:
• Before connecting the external components,
make sure that the unit is turned off.
*
4
Signal cord (not supplied for this unit)
External
component
3.5 mm stereo mini plug
B
Rear speakers
JVC Amplifier
Remote lead Y-connector (not supplied for this unit)
Remote lead (Blue with white stripe)
To the remote lead of other equipment or automatic antenna if any
Front speakers
External
component
ELECTRICAL CONNECTIONS
CD changer jack
Line out (see diagram )
Rear ground terminal
15 A fuse
Black
Blue with white stripe
Red
Yellow
*
2
To metallic body or chassis of the car
Ignition switch
Fuse block
To an accessory terminal in the fuse block
To the remote lead of other equipment (200 mA max.)
Right speaker (rear)
Purple
Left speaker (rear)
Purple with black stripeGreen
Right speaker (front)
Green with black stripe
Gray
Left speaker (front)
Gray with black stripeWhiteWhite with black stripe
To a live terminal in the fuse block connecting to the car
battery (bypassing the ignition switch) (constant 12 V)
Orange with white stripe
To car light control switch
To external components (see diagram
)
*
1
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to
installation, this lead must be connected, otherwise
power cannot be turned on.
Blue
To the automatic antenna if any (250 mA
max.)
CD changer, Apple iPod®, or JVC D. player
You can connect these components as illustrated below. The iPod*
5
or D. player
can be connected using an interface adapter (not supplied)—KS-PD100 (for
iPod) or KS-PD500 (for D. player).
*
6
Connecting cord supplied for your CD changer
Connecting the external components
C
• Set “CHANGER” for the external input setting (See page 14 of the INSTRUCTIONS.)
Apple iPod
(separately purchased)
JVC D. player
(separately purchased)
CD changer jack
JVC CD changer
*
5
iPod is a trademark of Apple Computer, Inc.,
registered in the U.S. and other countries.
*
8
AUX Input Adapter KS-U58 (not supplied for this unit)
or
Brown
To subwoofer (see diagram
)
To cellular phone system
JVC Amplifier
JVC Amplifier
Antenna connector
Front speakers
Subwoofer
Install_KD-G724[UI]f.indd 2Install_KD-G724[UI]f.indd 2 12/13/05 6:23:36 PM12/13/05 6:23:36 PM