Filter
Top Products
20
Listening to radio
2 Press DISPLAY (Radio Data
System) repeatedly.
PS (Program Service):
While the receiver is searching for Radio
Data System information, “WAIT PS”
appears and then the radio station names
will be displayed. “NO PS” appears if no
signal is received.
PTY (Program Type):
While the receiver is searching for Radio
Data System information, “WAIT PTY”
appears and then the type of the
broadcasted program will be displayed.
“NO PTY” appears if no signal is received.
RT (Radio Text):
While the receiver is searching for Radio
Data System information, “WAIT RT”
appears and then text messages sent by
the radio station will be displayed. “NO RT”
appears if no signal is received.
NOTE
• If the receiver takes time to show the Radio Data
System information received from a radio station,
“PS”, “PTY” or “RT” may appear in the display
window on the receiver.
• When PS, PTY or RT signals appear in the display
window on the receiver, irregular characters and
marks may not be displayed correctly.
Searching for programs by PTY codes
(PTY search)
You can locate a type of radio program by
specifying the corresponding PTY code.
• The PTY search is applicable only to the preset
radio stations.
7 When an FM radio broadcast is selected as the
sound source
1 Slide the remote control
mode selector to
RECEIVER.
2 Press SEARCH.
Display on the receiver
3 Press PTY + or PTY – repeatedly
to select a PTY code while “PTY
SELECT” is flashing.
Example:
When “Document” is selected as a PTY code
•Refer to page 21 for the PTY codes.
4 Press SEARCH.
• While the receiver is searching for a radio
program, “SEARCH” and the selected PTY
codes will be displayed.
Example:
When “Document” is selected as a PTY code
• The receiver searches 30 preset FM radio
stations, and stops when the receiver finds
the one you have selected. At this time the
selected frequency and PTY code flash.
When SEARCH is pressed while the
selected frequency and PTY code are
flashing, the receiver automatically starts
searching for the next radio station. After
the frequency and PTY code stop flashing
or if a button is pressed, the receiver
automatically tunes in to the radio station.
• To stop searching, press SEARCH.
• If no program is found, “NOT FOUND”
appears in the display window on the
receiver and the receiver returns to the last
received radio station.
For the locations of the remote
control buttons, refer to page 18.
EXA10[B].book Page 20 Thursday, August 4, 2005 10:01 PM