Filter
Top Products
6
Introduction
You can operate your TV using the remote control
of this system.
Setting the manufacturer code
1 Slide the remote control
mode selector to TV.
2 Hold down F TV.
• Hold down F TV until you finish step 4.
3 Press ENTER and release.
4 Press number buttons (1-9, 0).
• Refer to “Using the number buttons”
(A page 15).
Examples:
For a Hitachi TV: Press 0, then 7.
For a Toshiba TV: Press 2, then 9.
When the manufacturer of your TV has two or
more codes, select the manufacturer codes in turn
and find the one that operates the TV and the
remote control properly.
NOTE
• A manufacturer code is subject to change without
notice. You may not be able to operate the TV
produced by the manufacturer.
5 Release F TV.
Using the remote control for the TV operation
Operate the remote control by pointing it at the TV.
*1 Make sure to slide the remote control mode
selector to TV in advance.
NOTE
• After replacing the batteries of the remote control,
set the manufacturer code again.
• When the remote control mode selector is slid to TV,
some buttons may not work.
Operating the TV using
the remote control
F TV
TV/VIDEO
TV
CHANNEL
TV
VOLUME
ENTER
Number
buttons
Remote control
mode selector
Manufacturer Code Manufacturer Code
JVC 01 Nordmende
13, 14,18,
26-28
Akai 02, 05 Okano 09
Blaupunkt 03 Orion 15
Daewoo 10,31, 32 Panasonic 16,17
Fenner 04, 31,32 Philips 10
Fisher 05 Saba
13, 14,18,
26-28
Grundig 06 Samsung 10, 19,32
Hitachi 07,08 Sanyo 05
Inno-Hit 09 Schneider 02, 05
Irradio 02, 05 Sharp 20
Magnavox 10 Sony 21-25
Mitsubishi 11,33 Telefunken
13, 14,18,
26-28
Miver 03 Thomson
13, 14,18,
26-28, 30
Nokia 12, 34 Toshiba 29
Turns on/off the TV.
Changes the channels.
Adjusts the volume.
Selects the channels.
Switches the
previously selected
channel and the
current channel.
Switches the TV and video input.
/
/
~
*1
EXA10[B]-01.fm Page 6 Wednesday, August 24, 2005 12:38 PM