13
(Refer to page 17 for playing MP3 and JPEG.)
• The power will be turned on when any of ,
, or on the main unit and ,
, or on the remote control is
pressed while the power is off.
If any button other than or is
pressed, the source will also be changed (if
there is a disc loaded, playback will start).
NOTE
• A menu screen may be displayed after starting
playback of a DVD. In this case, select a desired
item to playback by using the following buttons on
the remote control.
• Select a desired item using and
press .
• Select a desired item using the number buttons.
• Depending on the disc, actual operation may be
different from the description.
Playback
1
3
2
A page 6
Place a disc with the label side
facing up.
• Place an 8 cm disc in to the
hollow part in the cen
ter.
Press F AUDIO.
• The power will be turned on and the STANDBY
lamp will go off.
• Press F AUDIO again to turn off the power.
Press 0 OPEN/CLOSE to open the disc
tray to load a disc.
Press 3 (play).
The disc tray will close and playback will start.
Screens displayed on the TV when the power is turned ON.
The following messages appear depending on the status of the system.
(When FM/AM or AUX is selected as a source, the messages do not appear.)
Appears when the system is reading the disc information. Wait for a while.
Appears when the Region Code of the DVD does not match the code the
system supports. (A page 3)
Appears when no disc is loaded.
Appears when opening the disc tray.
Appears when closing the disc tray.
Appears when trying to play back an unplayable disc.
NOW READING
REGION CODE
ERROR!
NO DISC
OPEN
CLOSE
CANNOT PLAY THIS
DISC
Playing discs
EXA1mkII[UJ]-03.fm Page 13 Wednesday, October 13, 2004 3:59 PM