Filter
Top Products
10
English
Using the Remote Control
Press the SOUND MODE button.
The display changes with each press of the button as shown below.
=D, CLUB=HALL=STADIUM=ROCK=POP=CLASSIC=MANUAL 1=MANUAL 2=
MANUAL 3=OFF=(back to the beginning)
Customizing a sound mode —————————————————————
You can change an existing sound mode to suit your own preferences. These changed setting can be
stored in the CA-D622T’s sound mode memory.
1. Select the sound mode you want to change.
If you select D. CLUB, HALL, or STADIUM, the surround effect remains unchanged, but you
can adjust the S.E.A. effect.
2. Press the SEA CONTROL button.
“SEA CONT” appears in the display, then the low tone section of the tone equalizer is displayed
and the MULTI CONTROL indicators light up to indicate the directions in which you can use
the controller.
Note: If no adjustments are made for 5 seconds after the SEA CONTROL button is pressed, Sound
mode appears on the display then reverts to the previous display.
3. Adjust the settings using the MULTI CONTROL stick.
❏ Adjust the level by adjusting the MULTI CONTROL stick up and down.
The level can be set between +3 and –3 in seven steps.
❏ Select the tone range by adjusting the MULTI CONTROL stick left and right.
You can select LOW, MID, or HIGH tones.
4. Press the SET button.
“MANUAL 1” appears on the display.
5. Select the memory number by adjusting the MULTI CONTROL stick left and right.
You can choose from “MANUAL 1” to “MANUAL 3”.
6. Press the SET button again.
“MEMORY” appears on the display and the settings are stored in the memory number selected.
❏ The sound mode is set to the settings you have stored.
❏ If you store new settings to a memory number that has already been used, the new settings
replace the existing setting.
SOUND MODE
SOUND MODE
SEA CONTROL
TIMER/CLOCK
SOUND
MODE
1234
567
VOL
SOUND
MODE
1234
567
VOL
SOUND
MODE
1234
567
VOL
SOUND
MODE
1234
567
VOL
SET
SOUND
MODE
1234
567
VOL
SET
SET
SOUND
MODE
1234
567
VOL
SET
CD
EN01-38.CA-D322T[C]/F 2/12/98, 10:28 AM10