Filter
Top Products
4
~
TV/monitor
• To select progressive scanning mode (see page 15), use
COMPONENT jacks.
• Connect the VIDEO jack, S-VIDEO jack, or
COMPONENT jacks whichever you want to use.
Ÿ
Digital audio component
• Set “DIGITAL AUDIO OUTPUT” in the “AUDIO” menu
correctly according to the connected digital audio
equipment (see page 38). If the setting is incorrect, loud
noise may be generated causing damage to the speakers.
!
Auxiliary equipment
⁄
AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
For better AM/FM reception
• Disconnect the supplied FM antenna, and connect to an
outdoor FM antenna using a 75
Ω
wire with coaxial type
connector (IEC or DIN45325).
• Make sure the antenna conductors do not touch any other
terminals, connecting cords or the power cord. Also, keep
the antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
Green
Blue
Red
S-video cord
(not supplied)
Composite video
cord (supplied)
Component video cord (not supplied)
OPTICAL
DIGITAL
OUTPUT
Protective cap
Red
White
Stereo audio cord
(not supplied)
Extend it so that you can obtain the best
reception.
AM loop antenna (supplied)
Turn it until the best reception is
obtained.
FM antenna (supplied)
AM loop antenna (supplied)
Keep it connected.
Vinyl-covered wire (not supplied)
Extend it horizontally.
FM outdoor antenna
(not supplied)
DX_T9[J].book Page 4 Tuesday, December 13, 2005 1:53 PM