Filter
Top Products
9
Adjusting the Volume
The volume level can be adjusted in 32 steps (VOLUME
MIN, VOLUME 1 – VOLUME 30, and VOLUME MAX).
To drop the volume in a moment
Listening to the Radio
To select the AM tuner interval spacing
Some countries space AM stations 9 kHz apart, and other
countries use 10 kHz spacing.
1
Select “TUNER AM,” then turn off (standby) the
System.
2
Select the AM tuner interval spacing.
To select the band (FM/AM)
To tune in to a station
While FM or AM is selected...
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency search stops.
• When you repeatedly press the button, the frequency
changes step by step.
To manually stop the searching,
press either button.
If the FM reception is poor
To preset stations
You can preset 30 FM and 15 AM stations.
1
Tune in to a station you want to preset.
• You can also store the monaural reception mode for FM
preset stations if selected.
2
Activate the preset number entry mode.
• Finish the following process while the indication on
the display is flashing.
• To cancel the operation during procedure, press
CANCEL while holding SHIFT.
3
Select a preset number for the station you store.
Remote control: Main unit:
To restore the volume,
press again or adjust the
volume level.
To select 9 kHz:
To select 10 kHz:
Remote
ONLY
(while holding...)
INFO
Main Unit
ONLY
TUNER FM
AUX
TUNER AM
(while holding...)
(while holding...)
TUNER FM TUNER AM
AUX
The MONO indicator lights on the
display. Reception will improve though
stereo effect is lost—monaural reception
mode.
To restore the stereo effect,
press the
button again (the MONO indicator goes
off).
• To select a number, see “How to
select a number” on page 8.
• You can also use ¢
/4
buttons.
1
sec.
Increases the frequency.
Decreases the frequency.
Remote
ONLY
Remote
ONLY
DX-J10_20_30[U].book Page 9 Friday,February 2, 2007 11:25 PM