JVC CA-DXJ35 Speaker System User Manual


 
5
Speakers
To connect the speaker cords
When connecting the speaker cords, match their polarity
with that of the speaker terminals: blue/red to (+) and black
to (–).
For CA-DXJ30
For CA-DXJ
20
For CA-DXJ1
0
Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the System.
The front speakers and subwoofer(s) are magnetically
shielded to avoid color distortions on TVs. However, if not
installed properly, it may cause color distortions. So, pay
attention to the following when installing the speakers.
When placing the speakers near a TV set, turn off the
TV’s main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV’s
main power switch again.
Some TVs may still be affected even though you have
followed the above instruction. If this happens, move the
speakers away from the TV.
@
Auxiliary equipment
¤
Voltage selector
(not applicable for Australian models)
#
Power cord
Plug the AC power cord to a wall outlet.
Press and hold
Insert
Release
From front right speaker
(blue/black)
From front left speaker
(blue/black)
From left subwoofer
(red/black)
From right subwoofer
(red/black)
From subwoofer
(red/black)
From front right
speaker (blue/black)
From front left speaker
(blue/black)
From front right speaker
(red/black)
From front left speaker
(red/black)
DO NOT connect more than one speaker to
each terminal.
DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
Use a screwdriver to rotate the
voltage selector so that the voltage
mark is pointing to the same
voltage as where you are plugging
in the unit. (See also the back cover
page.)
DO NOT plug in before setting the voltage
selector and all connection procedures are
completed.
Red
White
Stereo audio cord
(not supplied)
Voltage mark
DX-J10_20_30[U].book Page 5 Friday,February 2, 2007 11:25 PM