JVC CA-MXKA6 Stereo System User Manual


 
26
Using the Timers
Using the Unit
You can set the time in the same way as for setting the Daily Tim-
er.
1
Insert a blank or erasable tape into the Deck
B and wind past the tape leader.
2
Press the CLOCK/TIMER button until ON
TIME immediately after REC appears on
the display.
The Timer indicator ( ) lights and the REC indicator
blinks.
Each time you press the button, the display changes as follows:
DAILY = ON TIME = REC = ON TIME* = Clock setting
display = Canceled = (back to the beginning)
*: This item should be selected for the REC Timer setting.
Then, the System enters ON-time setting mode. The current
ON time appears on the display and the hour digits blink.
3
Setting the ON time you want the System to
turn on.
1. Press the 4 or ¢ button to set the hour, then press the
SET button.
2. Press the 4 or ¢ button to set the minute, then press the
SET button.
OFF TIME appears and then the System enters OFF-time
setting mode. The current OFF time appears on the display,
and the hour digits blink.
4
Setting the OFF time you want the System to
turn off.
1. Press the 4 or ¢ button to set the hour, then press the
SET button.
2. Press the 4 or ¢ button to set the minute, then press the
SET button.
The System enters Preset Station Entering mode.
5
Select the preset station for recording.
1. Press the 4 or ¢ button to set the band (TUNER FM or
TUNER AM), then press the SET button.
2. Press the 4 or ¢ button to set the preset number, then
press the SET button.
SET and OK successively appear on the display. The
REC indicator stops blinking and remains lit.
6
Press the button to turn off the System,
if necessary.
To confirm / change the timer setting
, repeat the setting pro-
cedure from the beginning.
When the timer ON-time comes:
When the timer ON-time comes, the System automatically
turns on. The station you have set is played. The Timer indica-
tor ( ) blinks during timer operation.
To stop timer recording, press the 7 button.
When the timer OFF-time comes, OFF blinks on the display
just before the OFF-time and the System automatically turns
off.
The REC Timer works even if the System is turned on.
Turning the REC (Recording) Timer On and Off
Once you have set the REC Timer to record a source, the timer set-
ting is stored in memory. So, though the REC Timer turns off once
it is used, you can recall it at any time.
To cancel the REC Timer temporarily:
1
Press the CLOCK/TIMER button on the Unit
repeatedly until REC appears on the dis-
play.
2
Press the CANCEL button on the Unit.
OFF appears and both the Timer indicator ( ) and the
REC indicator go out.
To activate the cancelled REC Timer:
1
Press the CLOCK/TIMER button on the Unit
repeatedly until REC appears on the dis-
play.
The Timer indicator ( ) lights and the REC indicator
blinks on the display.
2
Press the SET button on the Unit.
SET and OK successively appear on the display. The Tim-
er indicator ( ) and the REC indicator remain lit, and the
display returns to the original display.
CAUTION:
If the System is unplugged, or a power failure oc-
curs, the timer setting will be lost in a few days.
You will need to reset the clock first, then the
timer.
CA_MXKA6.book Page 26 Friday, February 7, 2003 7:56 PM