JVC CA-MXKA6 Stereo System User Manual


 
10
Using the Tuner
In AM (MW) broadcast, reception sensitivity will be chang-
ed by turning the AM (MW) loop antenna. Turn the AM
(MW) loop antenna for best reception.
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM (MW) sta-
tions.
Preset numbers may have been set to factory test fre-
quencies prior to shipment. This is not a malfunction. You
can preset the stations you want into memory by following
one of the presetting methods below.
During presetting stations, if no button operation is made
for 5 seconds, the display returns to the band/frequency
display. In this case, repeat steps from the beginning.
Using the Unit
1
Select a band by pressing the FM/AM button.
2
Press the
22
or
¡
button to tune in a
station.
3
Press the SET button.
SET will blink for 5 seconds.
4
Press the
4
or
¢
button to select the
preset number.
¢
: Increases the preset number by 1.
4
: Decreases the preset number by 1.
5
Press the SET button.
STORED appears and, after 2 seconds, the display returns to
the band/frequency display.
6
Repeat above steps 2 to 5 for each station
you want to store in memory with a preset
number.
To change the preset stations
, repeat the same steps as
above.
In step 4, you can select the preset number using the nu-
meric keys on the Remote Control. See Entering the
Number with the Remote Control on page 8.
CAUTION:
Even if the System is unplugged or if the power
failure occurs, the preset stations will be stored
for a few days. However, in case the preset sta-
tions are erased, you will need to preset the sta-
tions again.
To Change the FM Reception
Mode
When you are tuned in to an FM stereo broadcast, the ST (Ster-
eo) indicator lights up and you can hear stereo effects.
If an FM stereo broadcast is hard to receive or noisy, you can select
Monaural mode. Reception improves, but you lose stereo effect.
Press the FM MODE button on the Remote Control so
that the MONO indicator lights up on the display.
To restore the stereo effect
, press the FM MODE button on
the Remote Control so that the MONO indicator goes off.
Selecting other station will also cancel the FM Mono mode and re-
store the stereo effect.
TUNING
SET
or
FM=30, AM=15
SET
FM / AM
When changing the Band
FM MODE
ST MONO
CA_MXKA6.book Page 10 Friday, February 7, 2003 7:56 PM