JVC CA-MXJ206 Stereo System User Manual


 
– 24 –
English
6
Press SELECT – or SELECT + to
select the source to play, then press
SET.
Each time you press SELECT – or
SELECT +, the source changes as follows:
TUNER FM: tunes into a specified preset FM station.
= go to step 7.
TUNER AM: tunes into a specified preset AM station.
= go to step 7.
– CD – – –: plays a disc from a specified track of a
specified disc. = go to step 7.
• Make sure there is a CD on the selected disc
number tray.
TAPE: plays a tape in deck A or B. = go to step 8.
Make sure that a tape is in the deck whose deck
indicator (A or B) is lit on the display.
Make sure that the tape direction is correct.
AUX: plays an external source.= go to step 8.
To use this setting, the external component has to
be equipped with the timer function.
– CD – – –
TUNER FM
TUNER AM
TAPE
AUX
POWER
7
When selecting “– CD – – –”
1) Press SELECT – or SELECT + to select
the disc number, then press SET.
2) Press SELECT – or SELECT + to set the
track number, then press SET.
The unit enters volume setting mode.
When selecting “TUNER FM” or
“TUNER AM”
Press SELECT – or SELECT + to select the
preset station number, then press SET.
The unit enters volume setting mode.
8
Press SELECT – or SELECT + to
set the volume level.
You can select the volume level from
among four levels. If you select “ VOL –
– –,” the volume is set to the last level when the unit has
been turned off.
9
Press SET to complete the Daily
Timer setting.
The DAILY indicator stops flashing and
remains lit. The settings you have done are
shown on the display in sequence.
10
Press POWER to turn off the unit
(on standby) if you have set the Daily
Timer with the unit turned on.
DAILY
ST
RECSOUND MODE
BASS
Using Recording Timer
With Recording Timer, you can make a tape of a radio
broadcast automatically.
How Recording Timer actually works
The unit automatically turns on, tunes into the specified
station, sets the volume level to “MIN,” and starts recording
when the on-time comes (the indicator flashes just before
the on-time, and continues flashing while the timer is
operating). Then, when the off-time comes (“OFF” appears
just before the off-time), the unit automatically turns off
(stands by).
The timer setting remains in memory until you change it.
There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
If you have made a mistake while setting the timer, press
CANCEL. (However, this does not always work. If
CANCEL does not work, press CLOCK/TIMER repeatedly
and start from step 1 again.)
On the unit:
1
Put a recordable cassette into deck B.
2
Press CLOCK/TIMER until “REC”
appears on the display.
The REC indicator also starts flashing on the
display.
Each time you press the button, the timer setting mode
changes as follows:
3
Press CLOCK/TIMER again.
“ON TIME” appears for 2 seconds, then the
unit enters on-time setting mode.
CLOCK/TIMER
CLOCK/TIMER
DAILY
Canceled
ON TIME
ON TIME
Clock
setting
(See page 11.)
REC
REC
ST
RECSOUND MODE
REC
ST
RECSOUND MODE
REC
ST
RECSOUND MODE
– SELECT +
4
5
SET
8
– SELECT +
4
5
SET
8
– SELECT +
4
5
SET
8
Continued
MX-J300/206/200[C] 20-28 EN 00.4.10, 2:11 PM24