JVC CA-MXJ206 Stereo System User Manual


 
– 19 –
English
0 EJECT
0 EJECT
This unit provides two types of cassette deck: Deck A for
one-way playing only and deck B for Reverse Mode playing
as well as one-way playing.
You can play back only type I tapes.
Playing Back a Tape
1
Press EJECT (0) for the deck you want to
use.
2
Put a cassette in, with the exposed part of the
tape down.
3
Close the cassette holder gently.
If you put cassettes in both decks A and B, the last deck
you have put a cassette into is selected.
To operate the other deck, press TAPE A/B (or TAPE A
or TAPE B on the remote control).
4
On the unit:
Press TAPE
22
22
2
33
33
3.
On the remote control:
Press TAPE
33
33
3 for forward
direction playback, or press TAPE
22
22
2 for
reverse direction playback.
When the deck A is selected:
The tape plays only the front side and the tape direction
indicator (3) starts flashing slowly.
When the tape plays to the end, the deck automatically
stops.
When the deck B is selected:
The tape play starts and the tape direction indicator
(2 3) starts flashing slowly to indicate the tape
running direction.
Each time you press the button, the tape direction
changes:
33
33
3 : plays the front side.
22
22
2 : plays the reverse side.
When the tape plays to the end, the deck automatically
stops if the Reverse Mode is not on. (See “To play both
sides repeatedly — Reverse Mode.”)
Playing Back Tapes
For deck A
For deck B
To stop during play, press 7.
To operate the other deck, press TAPE A/B (or TAPE A or
TAPE B on the remote control), then TAPE 2 3.
To fast wind to the left or to the right, press 4 or ¢ (or
1 or ¡ on the remote control).
The tape direction indicator (2 3) starts flashing quickly on
the display.
To remove the cassette, press 0 EJECT for deck A or
EJECT 0 for deck B.
To play both sides repeatedly — Reverse Mode
Reverse Mode works for deck B.
When it is in use, the tape automatically reverses at the end of
a side and the unit starts playing the other side of the tape,
and repeats the same process.
To use Reverse Mode, press REVERSE MODE so
that the Reverse Mode indicator on the display lights
up as — .
Each time you press the button, the display changes to
show the following:
: The Cassette Deck automatically stops
after playing both sides of the tape.
(Stops when playback in the 2 direction
is finished.)
: The Cassette Deck continues to play both
sides of the tape until the 7 button is
pressed.
: The Cassette Deck automatically stops
after playing one side of the tape.
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator on the display lights up as — .
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
0 EJECT
TAPE
REVERSE MODE
MX-J300/206/200[C]15-19 EN 00.4.10, 2:11 PM19