Filter
Top Products
27
Using Recording Timer
With Recording Timer, you can make a tape of a radio
broadcast automatically. You can set the timer whether the
unit is on or off.
How Recording Timer actually works
The unit automatically turns on, tunes in to the specified
station, sets the volume level to “VOL MIN,” and starts
recording when the on-time comes (the indicator flashes
while the timer is operating). Then, when the off-time comes,
the unit automatically turns off (stands by).
Recording Timer works only once, but the timer setting
remains in memory until you change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step
2
again.
• If you have made a mistake while setting the timer, press
CANCEL/DEMO. (However, this does not always work. If
CANCEL/DEMO does not work, press CLOCK/TIMER
repeatedly and start from step
2
again.)
Before you start...
Make sure to preset a station you want to record. (See
page 12.)
On the unit ONLY:
1
Put a recordable cassette into deck B.
2
Press CLOCK/TIMER
repeatedly until “REC”
appears on the display.
indicator lights up and the REC (recording timer)
indicator starts flashing on the display.
• Each time you press the button, the clock/timer setting
modes change as follows:
3
Press CLOCK/TIMER again.
“ON TIME” appears for 2 seconds, then
the unit enters on-time setting mode.
DAILY
Canceled
ON TIME
(Recording Timer)
CLOCK
(See page 9.)
RECON TIME
(Daily Timer)
WOOFER
WOOFER
4
Set the on-time you want
the unit to turn on.
1) Press ¢ or 4 to set the
hour, then press SET/DISPLAY.
2) Press ¢ or 4 to set the
minute, then press SET/
DISPLAY.
“OFF TIME” appears for 2
seconds, then the unit enters
off-time setting mode.
5
Set the off-time you want
the unit to turn off (on
standby).
1) Press ¢ or 4 to set the
hour, then press SET/DISPLAY.
2) Press ¢ or 4 to set the
minute, then press SET/DISPLAY.
The unit enters preset station
selecting mode.
6
Select the preset station.
1) Press ¢ or 4 to select the
band (“TUNER FM” or
“TUNER AM”), then press
SET/DISPLAY.
2) Press ¢ or 4 to select a
preset channel number, then
press SET/DISPLAY.
The REC (recording timer)
indicator stops flashing and remains lit. The settings you
have done are shown on the display in sequence for your
confirmation.
7
Press STANDBY/ON to turn
off the unit (on standby) if
necessary.
About the recording source
If you change the source while recording, the recording source also
changes.
MXGB6&5[B]_23-32.p65 04.1.21, 5:33 PM27