Filter
Top Products
38 CA-EX70
6 Select the recording component (MD or
TAPE).
Press +/R or –/L so that the desired component is
blinking, then press SET.
• The blinking component is selected.
After SET is pressed, the display shows the start time,
the end time, the source, and the volume settings.
• If you plan to record while you are away, set the
volume to 0 before switching the power to the
STANDBY mode.
Timer operation
When the start time comes, the power turns on and
recording begins.
When the end time comes, the power automatically
switches to the STANDBY mode.
Switching the REC timer ON and OFF
The REC timer operates only once, but the settings are
stored in memory.
To use the same REC timer again, switch the REC timer ON
(the previous settings are still available).
To cancel the REC timer before the start time arrives,
switch the REC timer OFF.
Switching ON
Press CLOCK/TIMER, so that “REC” blinks in the display
(as described in step 1 of the main operations), then press
SET. The REC indicator lights up and the start time, the end
time, the source, and the volume settings appear in the
display.
Switching OFF
Press CLOCK/TIMER, so that “REC” blinks in the display
(as described in step 1 of the main operations), then press
CANCEL. The REC indicator turns off and “OFF” appears in
the display.
–
/L
+
/R
SET
CLOCK
/TIMER
CANCEL
EN27-39.CA-EX70[J]/1 98.6.8, 9:58 AM38