Filter
Top Products
– 25 –
English
CD Direct Recording
Everything on the CD goes onto the tape in the orderlayed
out on the CD.
On the unit ONLY:
1
Put a recordable cassette into deck B.
2
Load CDs.
3
Press one of the disc
number buttons (CD1,
CD2 and CD3) to select
the disc, then 7.
4
Press CD REC START.
“CD REC” appears, and the
(recording) indicator lights up on the
display.
Deck B starts recording and the CD player starts playing.
When the recording is done, “CD REC FINISHED”
appears on the display and deck B stop. CD player will
continue play for the next tray until you press STOP
button.
To stop recording, press REC START/STOP
or 7. So that a 4-second blank portion is
created on the recording tape. (Remember a
4-second blank is important when using
Music Scan — see page 23.)
• You cannot use CD Direct Recording to record a Program Play.
• Before recording on a tape, wind the tape on past the leader tape
(about the first 3 or 4 seconds of each side).
To record on both sides — Reverse Mode
Press REVERSE MODE so that the Reverse
Mode indicator lights up like — .
• When using the Reverse Mode for CD Direct
Recording, start recording in the forward (3)
direction first. When the tape reaches its end while
recording a song in the forward direction (3), the last song
will be re-recorded at the beginning of the reverse side (2).
If you start recording on the reverse side (2), recording
will stop when recording is done only on one side (reverse)
of the tape.
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator lights up — .
To record on both sides — Reverse Mode
Press REVERSE MODE so that the Reverse
Mode indicator lights up — .
• When using Reverse Mode for recording,
start recording in the forward (3) direction
first. Otherwise, recording will stop when recording is done
only on one side (reverse) of the tape.
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator lights up —
.
Dubbing Tapes
You can record from one tape to another.
On the unit ONLY:
1
Press TAPE 2 3, then 7.
2
Put the source cassette into deck A, and a
recordable cassette into deck B.
• Put the cassettes in both decks so that the tapes will run
in the forward (3) direction.
3
Press DUBBING.
The (recording) indicator lights up on
the display and dubbing starts.
To stop dubbing, press 7 so that both decks (A and B) stop.
To record on both sides — Reverse Mode
Press REVERSE MODE so that the Reverse
Mode indicator lights up — .
To cancel Reverse Mode, press the button
again so that the Reverse Mode indicator
lights up — .
Continued
EN24-35.CA-MXGA9V/8V/7V 7/4/03, 3:30 PM25