JVC CA-MXG780V Stereo System User Manual


 
– 23 –
English
You can playback type I, type II and type IV tapes without
changing any settings.
Playing Back a Tape
1
Press EJECT (0) for the deck you want to
use.
2
Put a cassette in with the exposed part of the
tape down.
3
Close the cassette holder gently.
If you put cassettes in both decks A and B, the last deck
you have put a cassette into is selected.
To select the other deck, press TAPE A/B.
4
Press TAPE 2 3.
The tape play starts and the tape
direction indicator (3 or 2) starts
flashing slowly to indicate the tape
running direction.
Each time you press the button, the
tape direction changes.
33
33
3 : plays the front side.
22
22
2 : plays the reverse side.
If no cassette is inserted, “NO TAPE” appears on the
display.
When the tape plays to the end, the deck automatically
stops if the Reverse Mode is off. (See “To play both sides
repeatedly — Reverse Mode.”)
To stop playing, press 7.
To operate the other deck, press TAPE A/B,
then TAPE 2 3.
To fast-wind to the left or to the right, press
1 or ¡ (4 PREV or ¢ NEXT on the remote
control) while the tape is not running.
The tape direction indicator (3 or 2) starts flashing quickly
on the display.
To remove the cassette, press 0 EJECT for deck A or
EJECT 0 for deck B.
Playing Back Tapes
To play both sides repeatedly — Reverse Mode
Reverse Mode works for both decks at the same time.
When it is in use, the tape automatically reverses at the end of
a side and the unit starts playing the other side of the tape,
and repeats the same process.
To use Reverse Mode, press
REVERSE MODE so that the Reverse Mode
indicator on the display lights up — .
To cancel Reverse Mode, press the button
again so that the Reverse Mode indicator on the
display lights up — .
When Reverse Mode is on with cassettes in both decks
A and B
After the reverse (2) side of the tape finishes playing, the tape in the
other deck starts playing.
Locating the Beginning of a Song
— Music Scan
You can use Music Scan to locate the beginning of a song.
Music Scan searches for blank portions that usually separate
recorded songs, then plays the next song.
To find the beginning of the current song
During play, press 1 or ¡ (4 PREV or
¢ NEXT on the remote control) in the
opposite direction to the tape play.
The tape direction indicator of the opposite
direction to the tape play starts flashing
slowly.
Searching stops automatically at the beginning of the current
song, and the current song starts automatically.
To find the beginning of the next song
During play, press 1 or ¡ (4 PREV
or ¢ NEXT on the remote control) in
the same direction as the tape play.
The tape direction indicator of the same
direction as the tape play starts flashing
slowly and quickly alternately.
Searching stops automatically at the beginning of the next
song, and the next song starts automatically.
Music Scan works by detecting a 4-second long blank
between each song, so it will not work well in the
following cases
No blank at the beginning of a song.
Noise (often caused by much use or poor quality dubbing) which
fills the blank.
Long, very soft passages or pauses in a song.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
For Deck A
For Deck B
EN14-23.CA-MXGA9V/8V/7V 7/4/03, 3:29 PM23