JVC CA-DXU8 Stereo System User Manual


 
9
Adjusting the Volume
The volume level can be adjusted in 32 steps (VOLUME
MIN, VOLUME 1 – VOLUME 30, and VOLUME MAX).
To drop the volume in a moment
Listening to the Radio
To select the AM tuner interval spacing
Some countries space AM stations 9 kHz apart, and other
countries use 10 kHz spacing.
1
Select “TUNER-AM,” then turn off (standby) the
System.
2
Select the AM tuner interval spacing.
To select the band (FM/AM)
To tune in to a station
While FM or AM is selected...
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency search stops.
• When you repeatedly press the button, the frequency
changes step by step.
To manually stop the searching,
press either button.
If the FM reception is poor
To preset stations
You can preset 30 FM and 15 AM stations.
1
Tune in to a station you want to preset.
You can also store the monaural reception mode for FM
preset stations if selected.
2
Activate the preset number entry mode.
Finish the following process while the indication on the
display is flashing.
• To cancel the operation during procedure, press
CANCEL.
3
Select a preset number for the station you store.
Remote control: Main unit:
To restore the volume, press again or
adjust the volume level.
To select 9 kHz:
To select 10 kHz:
AUDIO
VOL
Remote
ONLY
FADE
MUTING
INFO
Main Unit
ONLY
TUNER FM
TUNER AM
(while holding...)
(while holding...)
FM/AM/AUX
TUNER FM TUNER AM
AUX
The MONO indicator lights on the
display. Reception will improve though
stereo effect is lost—monaural reception
mode.
To restore the stereo effect,
press the
button again (the MONO indicator goes
off).
• To select a number, see “How to
select a number” on page 8.
• You can also use ¢
/4
buttons.
1
sec.
SLOW
Increases the frequency.
Decreases the frequency.
Remote
ONLY
FM/PLAY MODE
Remote
ONLY
ENTER
/SET
123
456
789
10 0
10
DX-U6[U].book Page 9 Monday, March 26, 2007 2:22 PM