Filter
Top Products
23
System Info (Chassis)
The System Info menu shows the ST2 Tuner’s
manufacturing build properties.
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press MEM Up/Down
until SYSTEM INFO appears on the tuner.
3. Press BAND.
4. Press BAND at “Build Time” to view.
5. Press MEM Up/Down to advance.
6. Press BAND at “Build Date” to view.
7. Press MEM Up/Down to advance.
8. Press BAND at “Version” to view.
9. Press TNR SEL to exit the System Info menu.
(END OF ST2 CHASSIS SETUP)
Tuner Setup Menu for AM/FM
It is important to select the desired tuner
(Tuner 1 or Tuner 2) using the TNR SEL but-
ton BEFORE accessing the Tuner Setup
Menus.
Memory Name (AM/FM)
A memory preset must be created and saved
before it can be named. Once it is saved, the
preset’s Tuner #, Bank # and Memory # must be
entered in the following procedure.
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press BAND again.
3. MEMOR
Y NAME appears on the tuner
.
4. Press BAND.
5. Bank # appears.
6. Press the Tune Up/Down buttons to select the
Bank #.
7. Press BAND to advance.
8. Press the Tune Up/Down buttons to select a
Memory #.
9. Press BAND to advance. MEMORY NAME
appears again.
10. Press BAND to access the Memory Name
entry screen.
11. Press Tune Up/Down to select a character
and MEM Up/Down to change a character posi-
tion. Up to 12 characters can be entered one by
one. A blinking cursor indicates the placement of
the character being entered.
12. Press BAND when memory name is entered.
13. SAVE CHANGES will appear.
14. Press Tune Up/Down to select Yes or No.
15. Press BAND to save memory name. The
Memory Name menu returns to the Tuner #
prompt to name other presets, or press TNR
SEL to exit the Memory Name menu.
Bank Name (AM/FM)
A custom name can be assigned to each of the
six banks of each tuner.
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press BAND.
3. MEMORY NAME appears. Press MEM
Up/Down until BANK NAME appears on the tuner.
4. Press BAND.
5. Bank # appears.
6. Press BAND to advance.
7. Press the Tune Up/Down buttons to select the
Bank #.
8. Press BAND. BANK NAME appears again.
9. Press BAND to access the Bank Name entry
screen.
10. Press Tune Up/Down to select a character
and MEM Up/Down to change a character posi-
tion. Up to 12 characters can be enter
ed one by
one. A blinking cursor indicates the placement of
the character being entered.
11. Press BAND when bank name is entered.
12. SA
VE CHANGES will appear
.
13. Press Tune Up/Down to select Yes or No.
(continued)
ST2 TUNER PROGRAMMING
ST2 TUNER SETUP MENU