Filter
Top Products
19
UNO-LRC1 Remote Control Operation
Turning the unit on
The tuner is power managed by the CAV6.6 or other
RNET-enabled controller. If the tuner is in standby
mode, any button press of the UNO-LRC1 will bring
the tuner out of standby mode when used with the
UNO keypad.
Selecting the desired tuner
To select a tuner, push and choose the source
number preassigned to Tuner 1 or Tuner 2, or use the
UNO numeric source inputs at the bottom of the
UNO-LRC1.
Selecting the desired band
Push to toggle between AM/FM reception.
Selecting the desired frequency
Use the Channel and or and
for manual tuning. To move quickly through the
stations, press and hold the button for more than 1.5
seconds. To directly select a station, enter the three-
or four-digit frequency (1071 for 107.1, etc.).
European regions use five-digit station frequencies.
Frequency Seek
The SEEK function is performed by pressing and
releasing the Select or or . To seek
higher frequency station press . Press for
lower frequencies. Tuning begins at the current fre-
quency, seeks upward (or downward) and stops at the
next tuned station. Pushing or again con-
tinues the SEEK function. Once the highest frequency
is reached, the tuner continues SEEK mode at the
lowest frequency.
Frequency Scan
To scan, press and hold then release . The
tuner scans through tuned stations with a 5-second
preview before moving to the next station. To end
scanning, press again.
Selecting a Bank
To select a bank, press and hold for bank up
or for bank down.
Recalling a Memory Preset
Press and or and to scroll
through a loop of all the memory presets for the cur-
rently selected bank. Only configured presets will be
displayed.
Mute
Press the button to mute/unmute the tuner
audio output.
ST2 OPERATION
UNO-LRC1 REMOTE CONTROL WITH CAV6.6