Filter
Top Products
21
ST2 Tuner Setup Menus
Note: The Setup Menu procedures must be performed from the ST2 Tuner front panel.
The ST2 Tuner Setup Menus provide setup and naming procedures for the ST2 main chassis, and
each AM/FM tuner module. These procedures include source number assignments, assigning a cus-
tom name to a memory preset or a bank, choosing a region for AM/FM operation (US or Euro), facto-
ry initialization and system information.
If the ST2 is used with a non-RNET system, the ST2 can be connected and operated without any
setup programming. Follow the setup menus if custom names are desired, or for system information.
If the ST2 is used with an RNET system such as CAV6.6, the following minimum setup must be per-
formed for the ST2 to be properly controlled by the CAV6.6.
1. ST2 Chassis Setup Menu - Assign source numbers to Tuner 1 and Tuner 2.
2. CAV6.6 Source Setup Menu - Assign the corresponding source numbers to Tuner 1 and Tuner 2.
3. CAV6.6 Source Setup Menu - Assign command type PERIPHERAL to Tuner 1 and Tuner 2.
NOTE: Once the programming procedures are completed, cycle power first to the Tuner and then to
the CAV6.6 (must be powered on last) to establish a connection.
ST2 Chassis Setup Menu
Source Number (Chassis)
The Source Number procedure permits Tuner 1
and Tuner 2 to be assigned the proper peripheral
source identities as will be assigned in the
CAV6.6 Source Setup.
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press MEM Up/Down
until SOURCE NUM appears on the tuner
.
3. Press BAND. TUNER # appears.
4. Press the Tune Up/Down buttons to select the
Tuner #.
5. Press BAND. SOURCE NUM appears.
6. Press the Tune Up/Down buttons to scroll
through the source numbers 1-6.
7. Press BAND to select the source number (as
assigned in the CAV6.6 setup process).
8. Repeat the process for the next tuner.
9. Press TNR SEL to exit the Source Number
menu.
Update Firmware (Chassis)
The Update Firmware procedure allows the ST2
tuner’s OS firmware to be updated. The proce-
dure is performed using a DB9 serial cable with
one end connected to the RS-232 port on the
back of the tuner and the other connected to a
PC or laptop. If an OS firmware update is avail-
able, it can be obtained thr
ough the Document
Center at
www.russound.com. XM tuner module
firmware must be performed by an authorized
Russound service facility.
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press MEM Up/Down
until UPDATE FIRMW appears on the tuner.
3. Press BAND to enter the UPDATE FIRMW menu.
(continued)
ST2 TUNER PROGRAMMING
ST2 TUNER SETUP MENU