Filter
Top Products
15
ST2 OPERATION
ST2-RC REMOTE CONTROL
ST2-RC Remote Control Operation
Turning the unit on
To take the ST2 tuner out of standby mode, push
or any other button except TUNER 1 or
TUNER 2.
Selecting the desired tuner
(Note: To change the tuner that is audio-active, you
must have some other system control in place to
change the source)
To control a tuner, push or . When
pressed, these buttons will be backlit green for Tuner
1 and amber for Tuner 2. Each time a tuner is select-
ed the display will refresh with the current station or
preset for that tuner,
and all subsequent button press-
es and memory preset entries will be associated with
that selected tuner.
Selecting the desired band
Push to switch between AM and FM reception.
Selecting the desired frequency
Use and for manual tuning. To move quickly
through the stations, press and hold either of the
Tune buttons for more than 1.5 seconds.
To directly select a station, press , and enter
the three- or four-digit station frequency (1071 for
107.1, etc.). European regions use five-digit station
frequencies.
Frequency Seek
The SEEK function is performed by pressing and
releasing to seek lower frequencies or for
higher fr
equencies. SEEK tuning begins at the curr
ent
fr
equency
, seeks upward and stops at the next tuned
station. Pushing continues the SEEK function.
Once the highest fr
equency is r
eached, the tuner con
-
tinues in SEE
K mode at the lowest frequency.
Selecting Stereo or Mono Output
Press to toggle between stereo and mono mode.
STEREO or MONO appears briefly on the screen when
selecting mode. Normal operation is in stereo mode.
On a preset, the stereo/mono setting is saved for
that preset.
Selecting Distant or Local Reception
Press to toggle between Distant and Local
mode. DISTANT or LOCAL appears briefly on the
screen when selecting mode. Normal operation is in
Distant mode.
Recalling a Memory Preset
To recall a memory preset, select the desired tuner,
press to select the desired bank, then press
and enter the desired preset number (1 to 6).
The memory presets can also be accessed by using
and to scroll through all presets for the
selected bank.
Saving Favorites
The remote control stores two “favorites” (similar to
memory presets) per tuner. These are set simply by
selecting either Tuner 1 or Tuner 2, setting the
desired frequency and pressing and holding or
until “FAV1 (2) saved” appears on the tuner.
Stored Favorites are then recalled by pressing either
or .
FAV 2
FAV 1
FAV 2
FAV 1
MEM
MEM
M
E
M
B
A
N
K
LOC/
DX
ST/
MONO
TUNE
TUNE
TUNE
AM/FM
TUNER 2
TUNER 1
PWR