Filter
Top Products
17
ST2 OPERATION
UNO-S2 KEYPAD CONTROLS WITH CAV6.6
CAV6.6-UNO-S2 Keypad Operation
NOTE: To control the ST2 Tuner through the
UNO-S2 keypad, the tuner must be configured
as a source using the CAV6.6 programming
steps.
Turning the unit on
The tuner is power managed by the CAV6.6 or
other RNET-enabled controller. If the tuner is in
standby mode, any button press of the UNO-S2
keypad will bring the tuner out of standby mode.
Selecting the desired tuner
On the UNO-S2 keypad, press to select
either Tuner 1 or Tuner 2 by choosing the
tuner’s preassigned source number.
Selecting the desired band
Push to toggle between AM band and FM
band reception.
Selecting the desired frequency
Use and for manual tuning. The fre-
quency will appear on the keypad and the active
tuner. To move quickly through the stations,
press and hold either or for more than
1.5 seconds
.
Frequency Seek
A press on will seek the next higher tune-
able station. If a tuneable station is not found,
end the SEEK function by pressing again.
Frequency Scan
To scan, press and hold then release . The
tuner scans through tuned stations with a 5-sec-
ond preview before moving to the next station.
To end scanning, press again.
Selecting a Bank
To select a bank, press and hold for bank
up or for bank down. The bank’s name will
be temporarily displayed on the UNO-S2.
Recalling a Memory Preset
Press and to scroll through the memo-
ry presets for the selected bank. This procedure
will step through all of the presets in the current
bank, then loop back to start at the first one.
Only configured presets will be displayed.
Mute
Press to mute/unmute the tuner audio out-
put.