Filter
Top Products
28
SN 29344365A
(C) Copyright 2006 ONKYO CORPORATION Japan. All rights reserved.
D0612-2
Integra Division of
ONKYO U.S.A. CORPORATION
18 park Way, Upper Saddle River, N.J. 07458, U.S.A.
Tel: 201-785-2600 Fax: 201-785-2650 http://www.integrahometheater.com
Integra Division of
ONKYO CORPORATION
Sales & Product Planning Div.: 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN
Tel: 072-831-8023 Fax: 072-831-8124
E
n
* 2 9 3 4 4 3 6 5 A *
Specifications
Amplifier Section
Video Section
General
■ Video Inputs
■ Video Outputs
■ Audio Inputs
■ Audio Outputs
■ Interface
Specifications and features are subject to change without
notice.
Rated Output Power (FTC)
Front L/R: 50 watts minimum continuous power
per channel, 8 ohm loads, 2 channels
driven at 1 kHz, with a maximum total
harmonic distortion of 0.05%
THD (Total Harmonic
Distortion)
0.05% (Power Rated)
0.05% (1kHz, 1W)
Damping Factor 60
Input Sensitivity and
Impedance 720 mV/22 kΩ (Unbalanced)
Preamplifier Output
Level and Impedance
( Z1 - Z4 L/R) +16 dB / 680 Ω
Frequency Response
20 Hz - 50 kHz/0 dB - 3 dB
Tone Control ±10 dB, 100 Hz (BASS)
±10 dB, 10 kHz (TREBLE)
Signal to Noise Ratio 95 dB (S1, IHA-A)
Speaker Impedance 6 Ω - 16 Ω
Input Level & Impedance
(S1 - S8) 1 Vp-p/75 Ω (Composite)
Buffered Video Output
Level and Impedance (S1
- S8) 1 Vp-p/75 Ω (Composite)
Output Level &
Impedance (Z1 - Z4) 1 Vp-p/75 Ω (Composite)
Power Supply AC 120 V, 60 Hz
Power Consumption 4.0 A
Standby Power
Consumption 21.4 W
Dimensions
(W
× H × D)
17-1/8"
×
5-5/8"
×
15-13/16"
Weight 27.8 lbs.
Composite S1 - S8
Composite Z1 - Z4
Analog Inputs S1 - S8
Zone Pre Output Z1 - Z4
Speaker Outputs Z1 - Z4 (L/R)
IR Output A, B, IR1, IR2 - 3.5mm phone Jack
Expansion Bus Input & Output - 34 way 0.1
"
Double Row
Header
12V DC 1 Amp Power Two DC power sockets, Center positive
(2.1mm pin diameter)
RS232 One DB9 - 9600 Baud
USB One : USB mini-B 5 pin
Controller Two: 4 way terminal blocks (0V, IR, 12V
& Data)
Amp On Control One: 7 way terminal plug with Amp ON 1
- 4 and #
One Page Preset Contact closure Input -
PG