Filter
Top Products
6
Insignia NS-STR514 Stereo Receiver with Bluetooth
www.insigniaproducts.com
Positioning your receiver
Your receiver requires space for ventilation. For best
performance:
• Do not install your receiver in an enclosed area.
• Do not block the ventilation openings on your
receiver.
• Do not place anything on top of your receiver.
• Make sure that you allow 8 in. (20 cm) of space
around both sides and the back of your receiver
and 16 in. (40 cm) above your receiver for correct
ventilation.
Connecting devices
Connecting an antenna
Connecting an indoor FM antenna
1 Connect the indoor FM antenna (included) to
the FM jack on the back of the receiver.
2 Move the antenna until you get the best
reception of your favorite FM stations.
Connecting an indoor AM antenna
1 Assemble the AM antenna.
2 Press the GND and AM Loop levers, insert the
ends of the wires, then release the levers. Make
sure that only the bare, stripped wire is inserted
in the jack.
3 Locate the AM antenna as far as possible from
the receiver, TVs, speaker cords, and the AC
power cord. Move the antenna until you get the
best reception of your favorite AM stations.
Caution
Connect the AC cord only after the speakers,
antenna, and all optional equipment have been
connected. Never make or change any connections
with the power turned on.
Notes
Be sure to observe the color coding when connecting
audio and speaker cords.
Make connections firmly and correctly. Failure to do
this can cause loss of sound, add noise to the sound,
or damage your receiver.
8 in.
(40 cm)
8 in.
(20 cm)
16 in.
(20 cm)
Front view
Side view
Back of
receiver
Back panel
Note
To improve reception, you may use a 75 Ω outdoor
antenna instead of an indoor antenna. Disconnect
the indoor antenna before replacing it with an
outdoor antenna.
Note
To improve reception, you may use an outdoor AM
antenna instead of a loop AM antenna. Disconnect
the indoor antenna before replacing it with an
outdoor antenna.
Indoor AM antenna
Back panel
NS-STR514_14-0118_MAN_V1_ENG.book Page 6 Thursday, March 6, 2014 10:53 AM