15
Insignia NS-STR514 Stereo Receiver with Bluetooth
www.insigniaproducts.com
Specifications
Preset stations
cannot be received.
• Memorize the correct station frequency.
• Memorize the stations again.
• Connect an antenna.
• Change the position of the antenna.
Continuous or
intermittent noise.
• Move devices, such as a TV or other appliance away from the
receiver or turn them off.
• Change the position of the antenna.
• Install an outdoor AM or FM antenna.
• Make sure that the antenna is properly secured.
• Make sure that you are tuned to the correct frequency.
No recording.
• Make sure that all devices are connected correctly.
• Operate each component correctly.
• Select the correct input source.
The sound lacks
bass.
• Check all speakers for correct polarity.
• Adjust the bass.
The volume of
SPEAKER A is
different from that
of SPEAKER B.
• Connect the same type of speakers to the SPEAKERS A and B
terminals if you want to use SPEAKERS A and B at the same time
with the same volume.
• Adjust the balance control.
I can hear the audio,
but I can’t see the
video on my TV.
• Select the input source that matches the device connected to
the TV.
Remote control isn’t
working.
• Replace the batteries.
• Remove the obstacles, such as furniture, between the remote
control and sensor on the receiver.
The display is too
dark or is off.
•Press DIMMER on the control panel repeatedly to return to the
default setting.
No sound or low
volume in Bluetooth
mode
• Make sure that your Bluetooth device turned on, Bluetooth is
turned on, and “NS-STR514” is selected.
• Turn up the volume on your receiver.
• Turn up the volume on your Bluetooth device.
• Make sure that your Bluetooth device is not muted.
• Make sure that you are playing music from your Bluetooth
device.
• Make sure that you have selected the Bluetooth source on your
receiver.
• Make sure that your receiver is not paired to another Bluetooth
device.
• Make sure that your Bluetooth device is not paired to another
Bluetooth device.
Cannot establish
Bluetooth
connection
• Shorten the distance between your receiver and your Bluetooth
device.
• Turn your devices off, then on. Re-pair your receiver and your
Bluetooth device.
• Make sure that your receiver is not paired to another Bluetooth
device.
• Make sure that your receiver and Bluetooth device are both in
pairing mode.
• Make sure that your Bluetooth device is not connected to any
other device.
• Make sure that you have selected “NS-STR514” on your
Bluetooth device.
My Bluetooth device
keeps unpairing
• Shorten the distance between your receiver and your Bluetooth
device.
• If battery on your Bluetooth device is low, recharge the battery.
“NS-STR514” does
not appear on my
Bluetooth device
• Shorten the distance between your receiver and your Bluetooth
device.
• Put your receiver into pairing mode, then refresh your list of
Bluetooth devices. For more information, see the
documentation that came with your Bluetooth device.
Problem Solutions
Notes
• Design and specifications are subject to change
without notice.
• Weight and dimensions shown are
approximate.
• Specifications and external appearance may be
changed for the sake of improvement.
Audio
Power output: Stereo mode, 8 Ohms (Ω),
THD 1%, 40 Hz~20 kHz:
2×100 W
Input sensitivity/impedance (CD): 420 mV
47 k ohms
Signal to noise ratio (CD): 95 dB
Frequency response (CD): 20 Hz~100 kHz: +/- 3 dB
Bass/Treble control: ±10 dB
FM Tuner Tuning frequency range: 87.5~107.9 MHz
Usable sensitivity, S/N 30 dB: 12 dBu
Signal to noise ratio, mono/stereo: 55/50 dBu
Distortion, mono/stereo: 0.7/ 1%
Stereo separation: 30 dBu @ 1kHz
IF rejection: 65 dB
Image rejection: 20 dB
AM Tuner Tuning frequency range: 530~1710 kHz
Usable sensitivity (S/N = 20 dB): 63 dBu/m
Signal to noise ratio: 35 dB
Selectivity (
±10 kHz
): 23 dB
IF rejection: 40 dB
General Power supply: 120 V ~ 60 Hz
Power consumption: 230W
Dimensions : 17.3 × 5.6 × 14.9 in.
(W×H×D, including protruding parts) (44 × 14.1 × 37.8 cm)
Weight (Net): 17 lbs (7.7 kg)
NS-STR514_14-0118_MAN_V1_ENG.book Page 15 Thursday, March 6, 2014 10:53 AM