Filter
Top Products
12
Insignia NS-STR514 Stereo Receiver with Bluetooth
www.insigniaproducts.com
2 To stop automatically presetting stations, press
the MEMO button on the remote control or the
MEMORY button on the receiver again.
Manually presetting radio stations
1 Tune to the station you want to preset.
2 Press the MEMO button on the remote control
or the MEMORY button on the receiver. MEM
blinks on the display.
3 Select a preset number between 1 and 30 by
pressing:
• The or buttons on the receiver.
-OR-
•The PRESET / buttons on the remote
control.
-OR-
• The number keys on the remote control.
4 Confirm your selection by pressing:
•The MEMORY button on the receiver.
-OR-
•The MEMO button on the remote control.
5 Repeat this procedure to memorize additional
stations.
Tuning to preset stations
1 Select the TUNER as the input source.
2 Press TUNE/PRESET to select the preset mode.
PRESET lights up.
3 Press the or buttons on the receiver or the
PRESET / buttons on the remote control to
select the preset station you want.
-OR-
Enter the preset number using the number keys
on the remote control.
Listening to FM stereo broadcasts
• While listening to an FM broadcast, press the
MO/ST button. Each time this button is pressed,
the FM mode changes as follows:
• Stereo mode—ST lights up.
• Mono mode—ST turns off.
Recording
Use your stereo receiver as a switch to connect your
audio sources to the audio recording device that is
connected to AUX 1 OUT or AUX 2 OUT. You can
record audio from the currently selected receiver
input source.
Notes
• Weak FM stations cannot be memorized.
• Auto preset can only be performed when you
select the FM as the input source. However, you
can manually preset AM stations or weak
stations.
Notes
• When using the numeric keypad on the remote
control, if your number is greater than nine,
enter the first digit, then enter the second digit
within two seconds.
• When using the numeric keypad, the station is
stored automatically without pressing the
MEMORY button on the receiver or the MEMO
button on the remote control.
• A stored frequency is erased from memory by
storing another frequency in its place.
• If MEM goes off, start again from step 3.
OR
OR
Note
When using the numeric keypad on the remote
control, if your number is greater than nine, enter the
first digit, then enter the second digit within two
seconds.
Notes
• When recording, the audio signals from AUX
inputs cannot be recorded on the same AUX
output jacks. (For example, the audio signal
from AUX 1 IN cannot be record on AUX 1 OUT.)
• The volume, tone (bass and treble), and balance
settings have no effect on the recording signals.
• When you select the tuner or CD as a recording
source, recording may be made on AUX 1, AUX
2, or both simultaneously.
OR
NS-STR514_14-0118_MAN_V1_ENG.book Page 12 Thursday, March 6, 2014 10:53 AM