Filter
Top Products
16
Insignia NS-R2001 AM/FM Stereo Receiver
www.insigniaproducts.com
Specifications Legal notices
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measure
-- Reorient or relocate the receiving antenna
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help
Warning: Changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
DHHS and FDA safety certification
This product is made and tested to meet safety standards of the
FCC, requirements and compliance with safety performance of
the U.S. Department of Health and Human Services, and also
with FDA Radiation Performance Standards 21 CFR Subchapter J.
Canadian Notice
This Class B digital apparatus complies with Canadian CAN
ICES-3 (B)/NMB-3(B).
This device complies with Industry license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device.
Ce dispositif est conforme à la norme de l'industrie RSS exempts
de licence (s). Son fonctionnement est soumis aux deux
conditions suivantes: (1) cet appareil ne peut pas provoquer
d'interférences et (2) cet appareil doit accepter toute
interférence, y compris les interférences qui peuvent causer un
mauvais fonctionnement du dispositif.
Notes
• Design and specifications are subject to change
without notice.
• Weight and dimensions shown are
approximate.
• Specifications and external appearance may be
changed for the sake of improvement.
Amplifier
Power output, stereo mode, 8 Ohms (Ω), THD 1%, 40 Hz~20 kHz: 2×100 W
Total harmonic distortion, 8 Ohms (Ω), 100 W, 40 Hz~20 kHz: 0.04%
Intermodulation distortion, 60 Hz:7 kHz= 4:1 SMPTE, 8 Ohms (Ω), 100 W:
0.02 %
Input sensitivity, 47 kΩ, Phono (MM): 2.5 mV
Input sensitivity, 47 kΩ, Line (CD, AUX1, AUX2): 420 mV
Signal to noise ratio, IHF “A” weighted, Phono (MM): 70 dB
Signal to noise ratio, IHF “A” weighted, Line (CD, AUX1, AUX2): 95 dB
Frequency response Phono (MM), RIAA, 30 Hz~20 kHz: +/- 3 dB
Frequency response Line (CD, AUX1, AUX2), 20 Hz~100 kHz: +/- 3 dB
Output level AUX1, AUX2 OUT, 2.2 kΩ: 200mV
Bass/Treble control, 100 Hz/10 kHz: ±10 dB
FM Tuner Tuning frequency range: 87.5~107.9MHz
Usable sensitivity, THD 3%, S/N 30 dB: 15 dBf
50 dB quieting sensitivity, mono/stereo: 25.2 / 45.2 dBf
Signal to noise ratio, 65 dBf, mono/stereo: 68/65 dB
Total harmonic distortion, 65 dBf,1 kHz, mono/stereo: 0.5 / 0.8%
Frequency response, 20 Hz~14 kHz: +/- 3 dB
Stereo separation, 1 kHz: 40 dB
Capture ratio: 4 dB
IF rejection ratio: 80 dB
AM Tuner Tuning frequency range: 530~1710 kHz
Usable sensitivity: 800 μV/m
Signal to noise ratio: 40 dB
Selectivity: 25dB
General Power supply: 120 V ~ 60Hz
Power consumption: 2.5 A
Dimensions (W×H×D, including protruding parts): 17.3 × 5.6× 14.9 inches
(44 × 14.1 × 37.8 cm)
Weight (Net): 17.4 lbs (7.9 kg)