Filter
Top Products
4
Insignia NS-A3111 DVD Executive Shelf System
www.insignia-products.com
• Attachments–Do not use attachments not
recommended by your shelf system
manufacturer because they may cause
hazards.
• Water and moisture–Do not use your shelf
system near water, for example, near a bath
tub, wash bowl, kitchen sink, or laundry tub,
in a wet basement, or near a swimming pool.
• Accessories–Do not place your shelf system
on an unstable cart, stand, tripod, bracket, or
table. Your shelf system may fall, causing
serious injury to someone and serious
damage to your shelf system. Use only with a
cart, stand, tripod, bracket, or table
recommended by the manufacturer, or sold
with your shelf system.
If you mount your shelf system,
follow the manufacturer's
instructions and use a mounting
accessory recommended by the
manufacturer. Move a shelf
system and cart combination
with care. Quick stops, excessive force, and
uneven surfaces may cause your shelf
system and cart combination to overturn.
• Ventilation–Slots and openings in the
cabinet and the back or bottom are provided
for ventilation, to ensure reliable operation of
your shelf system and to protect it from
overheating. Do not block openings. Do not
place your shelf system on a bed, sofa, rug,
or other similar surface. Your shelf system
should never be placed near or over a
radiator or heat register. Do not place your
shelf system in a built-in installation such as a
bookcase or rack unless correct ventilation is
provided or the manufacturer’s instructions
have been adhered to.
• Power sources–Use only the type of power
source indicated on the marking label. If you
are not sure of the type of power supply to
your home, consult your shelf system dealer
or local power company. For shelf systems
intended to operate from battery power, or
other sources, refer to the operating
instructions.
• Grounding or polarization–Your shelf
system is equipped with a polarized
alternating-current line plug (a plug having
one blade wider than the other). This plug will
fit into the power outlet only one way. This is
a safety feature. If you are unable to insert
the plug fully into the outlet, try reversing the
plug. If the plug should still fail to fit, contact
your electrician to replace your obsolete
outlet. Do not defeat the safety purpose of
the polarized plug.
• Power cord protection–Route power-supply
cords so that they are not likely to be walked
on or pinched by items placed upon or
against them, paying particular attention to
cords at plugs, convenience receptacles, and
the point where they exit from your shelf
system.
• Lightning–For added protection for your
shelf system during a lightning storm, or
when it is left unattended and unused for long
periods of time, unplug it from the wall outlet
and disconnect the antenna or cable system.
This will prevent damage to your shelf system
due to lightning and power-line surges.
• Power lines–An outside antenna system
should not be located in the vicinity of
overhead power lines or other electric light or
power circuits, or where it can fall into such
power lines or circuits. When installing an
outside antenna system, do not touch power
lines or circuits because contact with them
might be fatal.
• Overloading–Do not overload wall outlets
and extension cords because this can result
in a risk of fire or electric shock.
• Object and liquid entry–Never push objects
of any kind into your shelf system through
openings because they may touch dangerous
voltage points or short out parts that could
result in a fire or electric shock. Never spill
liquid of any kind on your shelf system.
• Servicing–Do not attempt to service your
shelf system yourself because opening or
removing covers may expose you to
dangerous voltage or other hazards. Refer all
servicing to qualified service personnel.
• Damage requiring service–Unplug your
shelf system from the wall outlet and refer
servicing to qualified service personnel under
the following conditions:
• When the power supply cord or plug is
damaged or frayed.
• If liquid has been spilled, or objects have
fallen into your shelf system.
• If your shelf system has been exposed to
rain or water.
• If your shelf system does not operate
normally by following the operating
instructions. Adjust only those controls
that are covered by the operating
instructions, because incorrect
adjustment of other controls may result in
damage and often requires extensive
work by a qualified technician to restore
your shelf system to its normal operation.
• If your shelf system has been dropped or
damaged in any way.
• When your shelf system exhibits a distinct
change in performance, this indicates a
need for service.
• Replacement parts–When replacement
parts are required, make sure that the
service technician uses replacement parts
specified by the manufacturer that have the
same characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock, injury to persons, or other
hazards.
• Safety check–Upon completion of any
service or repairs to your shelf system, ask
the service technician to perform routine
safety checks to determine that your shelf
system is in correct operating condition.