12
◆
HTS-20 Home-Theater System – Owner’s Manual
Observe polarities when making speaker connections, as shown in Figure 9 (below). Connect
each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on the
speaker. Connect the – (black) terminals in the same way.
Do not reverse polarities (i.e., + to – or – to +) when making connections.
C
ENTER
C
HANNEL
...
IMPORTANT!
Figure 9. The satellites and center-channel
speaker feature terminals that can be
connected in several different ways;
e.g., banana plugs, spade terminals and
direct wiring (as shown here).
Center Channel
(rear view)
Red = +
Black =
–
❷
Insert Bare
End; Tighten
Terminal
❶ Loosen
Terminal
Speaker Wire
Stripe =
+No Stripe =
–