Filter
Top Products
30 REMOTE CONTROL
Remote Control
Example: To program the Macro 1
K
button
so that it turns on the HS 350 and your TV,
follow these steps:
• Press the Macro 1 button
K
and Mute
A
buttons at the same time and then release
them.
• Note that the Program Indicator will flash
amber.
• Press the TV Selector
0
.
• Press the Mute
A
button to store the HS’s
power on command.
• Press the Screen Power On button
Y
button to store the TV Power On Command.
• Press the
MNKL
button
9
to complete
the process and store the macro sequence.
After following these steps, each time you press
the Macro 1 button
K
, the remote will send
all Power On commands.
Erasing Macro Commands
To remove the commands that have been
programmed into one of the Macro buttons,
follow these steps:
1. Press the Mute button
A
and the Macro
button
K
that contains the commands you
wish to erase.
2. Note that the Program Indicator
e
will
flash amber, and the red LED under the Input
Selector
0
last used will turn on.
3. Within ten seconds, press the Mute button
A
.
4. The red LED under the Selector will go out,
and the Program Indicator
e
will turn
green and flash three times before it goes out.
5. When the Program Indicator
e
goes out,
the Macro has been erased.
0096CSK - HK HS 350 OM ENG.qxp:34252_HS350_Eng 20/01/09 10:38 Side 30