Filter
Top Products
SPEAKER CONNECTIONS 11
Dolby Pro Logic*
(Non-Digital) – Line Level
USE THIS INSTALLATION METHOD FOR
DOLBY PRO LOGIC APPLICATIONS (NOT
DOLBY DIGITAL, DTS OR OTHER DIGITAL
PROCESSING), WHERE THE RECEIVER/
PROCESSOR IS EQUIPPED WITH A SUB-
WOOFER OUTPUT, OR A VOLUME-
CONTROLLED PREAMP (LINE-) LEVEL
OUTPUT:
Use the supplied RCA-type interconnect
cable to connect the
line-level subwoofer
output on your receiver
or amplifier to either
the left or right
Line-Level Full-Range
Input
§ on the SUB-TS8 subwoofer. Use
both the left and right inputs on the sub-
woofer if your receiver or processor has
both left and right line-level outputs. In that
case, you will need to supply a second
interconnect cable.
If your receiver is equipped with line-level out-
puts but does not have a separate subwoofer
output, use a Y-adapter (not supplied) to
bridge the receiver’s preamp output to the
main amp input for that channel, and connect
the long end of the adapter to the corre-
sponding line-level input on the SUB-TS8.
IMPORTANT: Do not use the SUB Input
∞ on the subwoofer with Dolby Pro Logic
processors.
If your receiver/processor has a built-in low-
pass-crossover filter for the subwoofer out-
put, you may use the
SUB Input ∞ to
bypass the subwoofer’s internal crossover.
Connect each speaker to the corresponding
speaker terminals on your receiver or amplifier.
Make sure that you have configured your
surround sound processor for
“Subwoofer
On.” The front left, front right, center and
surround speakers should all be set to
“Small.”
When all connections have been made, plug
the
AC power cord on the subwoofer into
an AC outlet.
SPEAKER CONNECTIONS
SUB/LFE
Out
Front
Left
Surround
Left
Front
Right
Surround
Right
SUB-TS8
Subwoofer
Center
Surround Back
L
ine-Level
R
L
Surround
Right
Front
R
ight
Surround
Left
Front
L
eft
C
enter
Receiver
Surround
Back
HKTS 8 OM 10/20/04 10:52 AM Page 13