Filter
Top Products
16
Setting the time
A demo programme starts when you connect the hi-fi system to the
mains for the first time. To end the demo programme switch the hi-fi
system to standby by pressing »ON/OFF« briefly. Now the time
and day displays will flash, indicating that they need to be set. The
following settings may only be performed in standby mode.
1 To set the 12-hour format, briefly press »PROG./RAND./
Ȅ«.
– Display: briefly »12HR«, then the current time, for example
»PM MON 12:02« (»PM« for the second half of the day).
2 To set the 24-hour format, press »PROG./RAND./
Ȅ« again.
– Display: briefly »24HR«, then the current time, for example
»MON 0:03«.
3 To set the time, press and hold down »PROG./RAND./
Ȅ«.
– Display: the hours flash.
4 Set the hours using »
c
TUNING/ALBUM
x
« and press
»PROG./RAND./Ȅ« to confirm.
– Display: the minutes flash.
5 Set the minutes using »
c
TUNING/ALBUM
x
« and press
»PROG./RAND./Ȅ« to confirm.
– Display: the day of the week flashes.
6 Set the day of the week using »
c
TUNING/ALBUM
x
« and
press »PROG./RAND./Ȅ« to confirm.
– Display: »CT ON« flashes.
7 Set the RDS time synchronisation with »
c
TUNING/ALBUM
x
« and confirm with »PROG./RAND./Ȅ«.
Notes:
You must reset the time after a power failure or when the mains
plug is pulled out.
Some RDS channels transmit an RDS time signal (CT). If the
selected RDS channel transmits this time information and the
RDS time synchronisation is set to »CT ON« on the hi-fi, then the
time is automatically updated (»
w« flashes in the display). This
takes about five minutes.
SETTINGS ______________________________________________
12
:
02
MON
0
:
03
MON
12
:
03
MON
PM
12
:
24
CT ON